Universal Remote Control User Guide

Programming Your Remote

It's simple to program your remote to control your TV.

CAN'T FIND YOUR CODE?

If you can't program your remote using the codes in this guide, follow the steps below to search for your code:

1. Turn on your TV.
2. On your remote, press and hold the Setup button until the red LED lights up.
3. Press the TV button.
4. Press and hold the Power button on the remote. Release the button as soon as the TV turns off.
5. Press the Setup button to lock in the code. The red LED will flash twice.

HERE'S HOW:

Follow the instructions above to program the remote control for your TV. Then, refer to the "Installing your HD Set-Top Box out of sight" section.

SAVE YOUR TV CODE

Once you have successfully programmed your remote, write down the code in the space provided in this guide for future reference.

ADVANCED TROUBLESHOOTING

If your remote is not working correctly after programming:

• Ensure the remote is aimed at the TV and is no further than 15 feet away.
• Check that the batteries are new and inserted correctly.
• Try searching for a different code for your TV brand.

FREQUENTLY ASKED QUESTION ABOUT PAIRING

Q: My remote is not responding. What should I do?

A: Make sure the remote is aimed at your TV and is no further than 15 feet away. Ensure the batteries are fresh and correctly inserted. If the issue persists, try reprogramming the remote.

Q: After my remote is programmed, these keys operate the TV's volume control. Is this normal?

A: Yes, this is normal. Many universal remotes are designed to control the TV's volume after setup.

Installing your HD Set-Top Box out of sight:

Follow these steps to ensure optimal performance when placing your HD Set-Top Box in a cabinet or behind furniture:

• Ensure there is adequate ventilation around the set-top box to prevent overheating.
• Position the box so that the remote control sensor is not obstructed.
• Avoid placing the box near sources of interference, such as microwaves or other electronic devices.

Remove remote control pairing

To remove the pairing between the remote control and your device, follow these steps:

1. Turn on the device you want to unpair.
2. Press and hold the Setup button on the remote until the red LED lights up.
3. Press the Device button (e.g., TV, SAT, DVD).
4. Press and hold the Clear button (or a combination of buttons as specified in your device's manual) until the red LED flashes twice.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Brand Code List

The following table lists various brands and their corresponding remote control codes. Use these codes to program your universal remote.