Manuals+

MantelMount MM860 Installation Instructions

IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS

Please read this entire manual before you begin. Do not unpack any contents until you verify all requirements on PAGE 3. If you have any questions, visit MantelMount.com or call (800)-897-9755.

Safety Warnings and Cautions

⚠️ WARNING! This product contains small parts that can be a choking hazard. Do not let children play with any of these small parts! Keep children away from the work area during installation.

⚠️ WARNING! Do not let children operate, pull on, or hang from MantelMount. Do not operate MantelMount when anyone is near or behind the mount. MantelMount is very strong and can result in crushing injuries.

⚠️ WARNING! MantelMount must be installed to a wall or structure that is able to hold five times the combined weight of all equipment. If you are unsure about your structure, a contractor must evaluate your installation.

⚠️ WARNING! Exceeding the weight capacity can result in serious personal injury or damage to equipment! The combined weight of all components must not exceed 125 lbs (57 kg).

❗ CAUTION: This product is intended to be installed by professional installation contractors, or persons familiar with the tools and methods required for this installation. If you are not sure about your ability to perform this installation, you must contact a professional. MantelMount is not responsible for damage or injury caused by incorrect installation or improper use.

❗ CAUTION: Do not use this product in any way, or for any purpose, that is not specifically described in these instructions. MantelMount is not responsible for damage or injury caused by incorrect installation or improper use.

U.S. Pat. No. 8,864,092 Other Patents Pending

Important Adjustments

IMPORTANT:

MantelMount has three different adjustments that must be made after the installation is complete in order to operate properly.

The side-to-side swivel stops are adjusted with two screws with locknuts so that the TV does not swivel into the mantel.

Tilt and yaw are removed using four screws behind the swivel mechanism. The TV should always be flat to the wall when stowed.

The bottom travel stop is adjusted with two screws and locknuts so the TV and mount do not lower all the way into the mantel.

Required Tools and Components

Required Tools:

A diagram shows required tools: 7/32" driver, 4-5mm driver, 10-14mm socket/wrench, and a power drill.

Before you begin, please verify that all components are included and undamaged. If any parts are missing or damaged, contact MantelMount. Never proceed with missing or damaged parts! Lay out all components and make sure you identify that each one has a match in the diagram. Some of the parts included will not be used during installation. Do not proceed if you do not understand and identify all of the components.

Silver Screws for back of TV:

  • {01} x4 M5x12
  • {02} x4 M5x30
  • {03} x4 M5x40
  • {04} x4 M6x16
  • {05} x4 M6x30
  • {06} x4 M6x40
  • {07} x4 M8x15
  • {08} x4 M8x25
  • {09} x4 M8x45

Black Parts for Mount: