SALUS RT510TX Thermostat and Receiver Pairing Guide

8. RT510TX Thermostat Pairing with the Receiver

The word PAIRING in the user settings means the function of synchronizing the transmitter with the receiver again, if it has been removed.

⚠️ WARNING! IN THE SET RT510RF THE THERMOSTAT IS FACTORY PAIRED WITH THE RECEIVER! In order to pair the devices correctly, you must first prepare the receiver for synchronization!

1. Diagram shows the SALUS receiver unit. It has a white casing with the SALUS logo. Below the logo are three switches labeled 'OFF', 'AUTO', 'MANUAL'. Ensure the receiver is disconnected from the power supply and the switches are in the AUTO and ON positions.

2. Diagram shows the SALUS receiver unit with the top switch moved to the 'ON' position. The switches are labeled 'ON', 'AUTO', 'MANUAL'.

3. Diagram shows the SALUS receiver unit. Connect the receiver to the power supply and wait for the red diode to glow continuously. Text indicates: "The red LED will start blinking, which will confirm that the receiver has entered the pairing mode."

4. Diagram shows the SALUS receiver unit. Move the top switch to the OFF position with a quick motion and back to the ON position.

5. Diagram shows the SALUS RT510TX thermostat display. It shows the current time '14:30', current temperature '25.0°C', and buttons labeled '+Hr', 'SELECT', 'SET', and 'TEST/PAIRING'.

6. Diagram shows the SALUS RT510TX thermostat display. It shows the current time '14:30', current temperature '10°C', and buttons labeled '+Hr', 'SELECT', 'SET', and 'TEST/PAIRING'.

7. Diagram shows the SALUS receiver unit with a continuously lit red diode. Text indicates: "When the red diode on the receiver lights up continuously, the devices have been paired on a new frequency."

8. Diagram shows the SALUS RT510TX thermostat display. Text indicates: "Press and hold TEST / PAIRING button for 3 seconds."

Thermostat pairing process. It can take up to 10 minutes.

Press and hold TEST / PAIRING button for 3 seconds to end pairing process. Thermostat will go back to the main screen and it has been paired successfully.

9. Test the Pairing Process

It is important to place the receiver and transmitter in places where nothing interferes with the radio signal. The range of communication between the transmitter and the receiver in an open area is up to 60m. The radio transmission is influenced by many factors that can shorten the working distance, such as thick walls, drywall covered with aluminum foil, metal objects such as cabinets, general radio interference, etc. However, the range is sufficient for most domestic use. It is recommended to test the radio transmission between devices before mounting the regulator on the wall. The test can be performed by changing the set temperature, i.e. by activating or deactivating the heating.

1. Diagram shows the SALUS RT510TX thermostat display showing '25.0°C'. Text indicates: "Press TEST / PAIRING button to check the connection with the receiver."

2. Diagram shows the SALUS RT510TX thermostat display showing '10°C' and an antenna icon. Text indicates: "Antenna icon will display. Test mode can take up to 9 minutes."

3. Diagram shows the SALUS receiver unit. Text indicates: "The red LED and the green LED on the receiver will begin to flash."

4. Diagram shows the SALUS RT510TX thermostat display. Text indicates: "Press TEST / PAIRING button again to return to the main screen."

5. Diagram shows the SALUS receiver unit. Text indicates: "Receiver will go back to normal work mode."

ℹ️ If you purchased an RXRT510 or RT510TX and intend pairing with other devices in the 5x5 range, please refer to the Receiver Units manual or the relevant manuals available at www.salus-controls.eu