ART+SOUND AR2010 Sound Base User Manual

Introduction

This user manual provides essential information for the ART+SOUND AR2010 Sound Base. It covers setup, operation, safety precautions, and troubleshooting to ensure optimal performance.

In The Box

ART+SOUND AR2010 Sound Base unit
Remote Control
Optical Cable
3.5mm to RCA Audio Cable
Power Cable

Location Of Controls

Top Panel Controls

The top panel of the sound base features the following controls:

Power Button: Turns the unit on or off.
Volume Up Button: Increases the audio volume.
Volume Down Button: Decreases the audio volume.

Rear Panel Connections

The rear panel provides ports for connecting audio sources and power:

LINE-IN (3.5mm): For connecting devices with a 3.5mm audio output.
AUX (RCA): For connecting devices with RCA audio outputs.
Power Input: Connect the provided power cable here.

Connecting The Speaker/Sound Base

Bluetooth Pairing

To connect wirelessly via Bluetooth:

Press and hold the Power Button on the sound base for approximately 3 seconds to enter Bluetooth pairing mode.
On your Bluetooth-enabled device (e.g., smartphone, tablet), navigate to Bluetooth settings and search for available devices.
Select "ART+SOUND" from the list of found devices.
Once paired successfully, a blue indicator light on the sound base will confirm the connection.

Wired Connections

For wired audio input:

LINE-IN (3.5mm): Connect one end of the 3.5mm audio cable to the LINE-IN port on the sound base and the other end to the audio output of your TV or audio source.
AUX (RCA): Connect the RCA audio cables from your TV or audio source to the AUX ports on the sound base. Ensure correct color matching (e.g., red to red, white to white).
Connect the power cable to the Power Input port and plug it into a wall outlet.

Using The TV Sound Base

Power On/Off: Press the Power Button on the unit or the remote control.
Volume Adjustment: Use the Volume Up and Volume Down buttons on the unit or the remote control.
Input Selection: Use the dedicated input buttons (Bluetooth, LINE-IN, AUX) on the remote control to switch between audio sources.

Installing The Batteries

The remote control requires two AAA batteries (not included).

Open the battery compartment cover on the back of the remote control.
Insert two AAA batteries, paying close attention to the polarity markings (+ and -) inside the compartment.
Replace the battery compartment cover securely.

Safety Instructions

Please read and follow all safety instructions before operating the ART+SOUND AR2010 Sound Base:

Read all instructions carefully before use.
Keep the unit away from water, moisture, and high humidity environments.
Do not expose the unit to direct sunlight or place it near heat sources such as radiators or stoves.
Ensure adequate ventilation around the unit; do not block any ventilation openings.
Do not attempt to open, disassemble, or repair the unit yourself. Refer all servicing to qualified personnel.
Keep the unit and its accessories out of reach of children.
Do not place heavy objects on the unit that could cause damage or block airflow.
? Do not place the unit on unstable surfaces or carts where it may fall.
? Do not cover the unit or block its ventilation openings.
? Keep the unit away from flammable materials and liquids.
⚠️ Do not operate the unit with a damaged power cord or plug.
⚠️ Do not immerse the unit in water or any other liquid.
⚠️ Avoid dropping the unit or subjecting it to strong impacts.
⚠️ Ensure the unit is placed on a stable, level surface.
⚠️ Do not place the unit near sources of heat or in damp environments.
⚠️ Use only the power adapter supplied with the unit.
⚠️ Keep the unit and its accessories out of reach of children.
⚠️ Do not disassemble or attempt to repair the unit yourself. Contact qualified service personnel.
⚠️ Ensure proper ventilation around the unit.
⚠️ Do not place objects on top of the sound base that could block ventilation or cause damage.
⚠️ Avoid exposure to extreme temperatures.
⚠️ Do not use the unit outdoors.
⚠️ Keep the unit away from strong magnetic fields.
⚠️ Clean the unit only with a dry, soft cloth. Do not use liquid cleaners or aerosol cleaners.
⚠️ Dispose of batteries properly according to local regulations. ♻️

Legal Information and Limited Warranty

Limited Warranty

ART+SOUND warrants this product against defects in material and workmanship under normal use for a period of ONE (1) YEAR from the date of original retail purchase. This warranty is non-transferable and is valid only for the original purchaser of the product.

Warranty Exclusions

This warranty does not cover:

Damage resulting from accident, misuse, abuse, neglect, or unauthorized modification.
Cosmetic damage, including scratches or dents.
Damage caused by acts of nature, such as lightning strikes or floods.
Damage resulting from improper installation or connection to an incorrect power supply.
Products where the serial number has been removed or defaced.

Obtaining Warranty Service

To obtain warranty service, the original purchaser must contact ART+SOUND customer support and provide proof of purchase (e.g., sales receipt). ART+SOUND will, at its option, repair or replace the defective product with a new or refurbished unit.

Disclaimer

The information contained in this manual is subject to change without notice. ART+SOUND shall not be liable for any incidental or consequential damages arising from the use or inability to use this product.

Troubleshooting Tips

No Sound Output

Ensure the sound base is powered on and the volume is not set to mute or minimum.
Verify that the correct audio input source (Bluetooth, LINE-IN, AUX) is selected on the sound base.
Check that all audio cables are securely connected to both the sound base and the audio source device (TV, etc.).

Bluetooth Connection Issues

Confirm that the sound base is in Bluetooth pairing mode (indicated by a flashing blue light).
Ensure Bluetooth is enabled on your source device (smartphone, tablet, etc.).
Move your Bluetooth device closer to the sound base to improve signal strength.
Try turning the Bluetooth function off and then on again on your source device.
If previously paired, try "forgetting" the ART+SOUND device in your device's Bluetooth settings and re-pairing.

Distorted or Unclear Sound

Reduce the volume level on the sound base and/or the source device.
Check the audio source itself for any distortion or quality issues.
Ensure that audio cables are not damaged and are properly seated.

Additional Warnings and Precautions

Please observe the following additional precautions for safe and proper use:

Do not use the unit in environments with excessive dust, humidity, or extreme temperatures.
Avoid placing the unit near sources of electromagnetic interference.
Ensure the power cord is not pinched, kinked, or placed under heavy objects.
Disconnect the power cord during lightning storms or when unused for long periods.
Do not use any attachments or accessories not recommended by ART+SOUND, as this may cause damage or injury.
The sound base is designed for indoor use only.
Handle the remote control with care; avoid dropping it.

	ART+SOUND AR4001 Retro 6-in-1 Entertainment System User Manual Comprehensive user manual for the ART+SOUND AR4001 Retro 6-in-1 Entertainment System, covering setup, operation of turntable, CD player, cassette player, AM/FM radio, Bluetooth, and wired speaker functions, along with safety and warranty information.
	ART+SOUND ARBT10 True Wireless Earbuds User Manual - Pairing, Charging, and Operation Guide Comprehensive user manual for ART+SOUND ARBT10 True Wireless Earbuds with Charging Case. Learn how to charge, pair, play music, and handle calls. Includes safety, warranty, and FCC information.
	ART+SOUND ARTWS110 True Wireless Earbuds User Manual & Guide Comprehensive user manual for ART+SOUND ARTWS110 True Wireless Earbuds. Learn about setup, pairing, controls, charging, and warranty information.
	ART+SOUND AR3092 3.1 Surround Sound System User Manual User manual for the ART+SOUND AR3092 3.1 Surround Sound System, covering setup, operation, and compliance information.
	ART+SOUND CYBER SYNC ARCYBR100 User Guide User manual for the ART+SOUND CYBER SYNC ARCYBR100 Wireless LED Portable Speaker. This guide provides setup instructions, button functions, Bluetooth pairing, LED light modes, technical specifications, and warranty information. Learn how to charge and operate your speaker safely.
	ART+SOUND AR655 Mini Wireless Bluetooth Speaker User Manual User manual for the ART+SOUND AR655 Mini Wireless Bluetooth Speaker, covering setup, pairing, usage, charging, wired connection, and limited warranty information.
	ART+SOUND AR520 Bluetooth Wireless Portable Speaker User Manual User manual for the ART+SOUND AR520 Bluetooth Wireless Iridescent Portable Speaker, covering setup, charging, pairing, wired connection, and warranty information.
	ART+SOUND AR3005 Wireless Vintage Radio User Manual - Pairing, Operation, and Warranty Comprehensive user manual for the ART+SOUND AR3005 Wireless Vintage Radio. Learn how to pair Bluetooth devices, operate the speaker, use FM radio, auxiliary input, and understand the 90-day limited warranty.