ART+SOUND AR4001 Retro 6-in-1 Entertainment System

Introduction

This document provides instructions for operating the ART+SOUND AR4001 Retro 6-in-1 Entertainment System.

Brand: ART+SOUND

Model: AR4001

In the Box

• Retro 6-in-1 Entertainment System
• AC Adaptor
• AUX-IN Cable
• User Manual

Location of Controls

Front Panel Controls

The front panel features the following controls:

• 1. Turntable cover: Protective cover for the turntable.
• 2. Volume dial - Power ON/OFF: Controls volume and powers the unit on/off.
• 3. AM/FM Radio tuner: Dial for selecting radio stations.
• 4. Function dial: Selects the operating mode (e.g., Bluetooth, CD, FM, AM, TAPE, PH).
• 5. Prev button: Skips to the previous track or station.
• 6. Next button: Skips to the next track or station.
• 7. AM/FM button: Switches between AM and FM radio bands.
• 8. CD Tray: Compartment for the CD.
• 9. PLAY/PAUSE button: Starts or pauses playback.
• 10. STOP button: Stops playback.
• 11. CD OPEN/CLOSE button: Opens or closes the CD tray.
• 12. LED display: Shows current status, track information, etc.

Back Panel Controls

The back panel includes:

• 13. AUX input: Port for connecting external audio devices via cable.
• 14. DC IN port: Port for connecting the AC power adaptor.
• 15. FM antenna: Wire antenna for improved FM reception.

Side Panel Controls

• 23. Tape Eject/Fast-Forward button: Ejects the cassette or fast-forwards.
• 24. Cassette deck: Slot for inserting cassette tapes.

Turntable Components

• 15. Turntable pickup: The stylus (needle) that reads the record.
• 16. Tone arm: Holds the pickup and is placed on the record.
• 17. Speed control switch: Selects playback speed (33, 45, 78 RPM).
• 18. Tone arm lock: Secures the tone arm when not in use.
• 19. Control perch: Rest for the tone arm.
• 20. 45 RPM adaptor: Adapter for records with large center holes.
• 21. Turntable: The rotating platter where the record is placed.

Connecting the AC Adaptor

1. Connect the small end of the AC adaptor to the DC5V port on the back of the unit.
2. Plug the AC adaptor into a power outlet.
3. Slide the [Power ON/OFF] switch to the ON position.

Using the AM/FM Radio

Adjusting the Sound

Turn the Volume dial on the left side of the system to adjust the sound level.

Selecting an FM Radio Station

1. Turn the Volume / Power ON/OFF dial to the ON position.
2. Set the Function Knob to the FM position.
3. Turn the FM radio tuner dial to select an FM radio station.

Selecting an AM Radio Station

1. Switch the AM/FM button to AM.
2. Turn the FM radio tuner dial to select the AM channel.

Antenna

For best FM reception, extend the wire antenna located at the back of the unit and move it to find the optimal position for clear reception.

Using the CD Player

Loading a CD

1. Turn the Volume / Power ON/OFF dial to ON and set the Function Knob to CD.
2. Press the OPEN/CLOSE button to open the CD tray. Do not force it open manually.
3. Place the CD on the tray with the label side facing upwards.
4. Press OPEN/CLOSE again to close the CD tray.

Playing CDs

• Press the PLAY/PAUSE button to start or pause playback. The LED screen will show [||] when paused.
• Press the STOP button to cease playback.
• Press the PLAY/PAUSE button again to resume playback.
• Use the PREV/NEXT buttons to navigate between tracks.

Using the Cassette Player

1. Turn the Volume / Power ON/OFF dial to ON.
2. Turn the Function dial to the TAPE position.
3. Insert a cassette tape into the Cassette Deck on the left side panel.

Tape Eject / Fast Forward Button

• Quick press the button to fast forward the tape.
• Press and hold the button inward to eject the cassette.
• The tape will stop automatically when it finishes playing.

Using the Turntable

1. Turn the Volume / Power ON/OFF dial to ON. Set the Function dial to the PH (phonograph) position.
2. Place the record on the turntable.
3. Select the correct speed (33, 45, or 78 RPM) for the record.
4. Remove the stylus guard. Push the lift lever upward to raise the tone arm. Gently move the tone arm over the record. The platter will start rotating automatically. Slowly lower the lift lever to place the stylus on the record.
5. To pause playback, push the arm lift lever up. The platter will continue to spin. Lower the lever to resume playing.

How to Replace the Stylus

Follow these steps to replace the needle:

1. a. Removing the Needle from the Cartridge: Place a screwdriver at the tip of the needle head and push downwards as shown in the diagram.
2. b. Remove the needle head shell: Pull it forwards and push downwards.

Pairing the Speaker with a Bluetooth Enabled Device

1. Turn the Volume / Power ON/OFF dial to ON.
2. Turn the Function dial to the BT (Bluetooth) position. The word "BLUE" will flash quickly on the LED screen.
3. Keep the turntable and your Bluetooth device within 3 feet (approx. 1 meter) of each other during pairing.
4. Set your Bluetooth device to search for Bluetooth devices.
5. When your device finds the turntable, select "AR4001" from the list.
6. If prompted, enter the password "0000". Select OK or Yes to pair.
7. After successful pairing, the word "BLUE" will remain solid on the LED screen.

If no paired devices are in range when the speaker turns on, it enters pairing mode automatically. If a paired device is in range, it will connect automatically.

Note: The interface of your Bluetooth device may differ slightly from the illustrations provided.

Using as a Wired Speaker (AUX Input)

1. Turn the Volume / Power ON/OFF knob to ON.
2. Set the Function Knob to the AUX position. The word "LINE" will appear on the LCD.
3. Connect the included Audio cable to the AUX-IN port on the back of the speaker (white end to white port, red end to red port, if applicable, otherwise connect as indicated).
4. Connect the 3.5mm Auxiliary end of the cable to the output jack on your computer, mobile phone, or tablet.
5. Open a media player on your device and press Play to start listening.

Legal Information

FCC Compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Laser Product Warning: This set employs an optical laser beam system in the CD mechanism designed with built-in safeguards. Do not attempt to disassemble. Exposure to this invisible laser light beam may be harmful to the human eye. This is a Class 1 laser product. Use of controls, adjustments, or procedures other than those specified herein may result in hazardous laser light beam exposure. This compact disc player should not be adjusted or repaired by anyone except qualified service personnel.

Safety Warnings:

• ⚡️ DANGER ⚡️: Warning sign alerting you to dangerous voltage inside the product.
• ⚠️ CAUTION: RISK OF ELECTRIC SHOCK. DO NOT OPEN. Refer servicing to qualified service personnel.
• ? CLASS I LASER PRODUCT ?: Warning sign alerting of important information accompanying the apparatus.
• ? Do not expose the unit to extreme temperatures (heat or cold), open flames, humid conditions, or wet conditions. Do not submerge in water.
• Do not open this product or attempt to repair the unit yourself should it not be working.

Safety Information

• This appliance is for household, indoor use only.
• Please do not use or store the unit in high temperature or hazardous locations.
• Please do not submerge the unit into water, as this will damage the speaker.
• To avoid injury, ensure the device is dry and away from moisture before operating.
• The warranty for this product is invalidated if the product has been tampered with, repaired, or modified in any way.
• Do not listen to music at high volume for extended periods, as it may cause damage to your ears.

Important Safety Instructions

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use the product for any purpose other than its intended use.

Limited Warranty

90 Days Limited Warranty

If this product is defective or does not perform properly, you may return it within ninety (90) days from the original date of purchase to the authorized service center for repair or exchange.

To Obtain Warranty Service:

• Call the Customer Support number or visit the website to receive an SRO number.
• Provide proof of purchase (dated bill of sale) with the return package.
• Prepay all shipping costs to the authorized service center and insure your return.
• Include a return shipping address (no P.O. Boxes), a telephone contact number, and the defective unit in the package.
• Describe the defect or reason for return.

Your product will be repaired or replaced, at the option of the service center, with a similar model of equal value if examination determines it is defective. Products received damaged due to shipping require filing a claim with the carrier.

Authorized Service Center Address:

Customer Service Dept. 36
c/o Southern Telecom
400 Kennedy Drive
Sayreville NJ 08872

Warranty Service Not Provided: This warranty does not cover damage resulting from accident, misuse, abuse, improper installation or operation, lack of reasonable care, or unauthorized modification. This warranty is void if any unauthorized person opens, alters, or repairs the product.

Limitation of Warranty: The warranty stated above is the only warranty applicable. All other warranties, express or implied (including implied warranties of merchantability or fitness for a particular purpose), are disclaimed. No verbal or written information given by ART, INC., its agents, or employees shall create a guaranty or increase the scope of this warranty. Repair or replacement is the exclusive remedy. ART, INC. is not liable for incidental or consequential damages. This disclaimer is governed by the laws of the State of New York. Limitations on implied warranties may not apply if prohibited by applicable law.

Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.

Contact Information

For questions or problems concerning this product, please contact customer service:

Phone: 1-877-768-8481 (Monday - Friday 8AM-10PM EST)

Website: www.southerntelecom.com (Click on Product Support)