20w Marietta Floor Lamp

Congratulations!

You've purchased the finest in natural lighting technology with your new OttLite® product.

Step 1: Product Registration Form

Please complete the enclosed Product Registration Form and return it today by mail, or register online by going to: www.ott-lite.com/warranty.

⚠️ WARNING: To prevent electric shock, make sure the lamp is not plugged in until all assembly steps are complete.

Step 2: Lamp Assembly

Diagram Description: An exploded view shows the lamp components: Base (A), Lower Pole (B), Middle Pole (C), Upper Pole (D), Shade (E), Socket Ring (F), Socket Assembly (G), Thumb Levers (J, K), Switch (L), and Bulb (M). The parts are arranged to illustrate the assembly process.

1. Make sure the lamp is not plugged into an electrical socket.
2. Unpack all lamp parts and lay out on the floor with the base (A) lying flat.
3. Thread middle pole (C) to upper pole (D) by hand, turning clockwise until tight.
4. Thread lower pole (B) to middle pole (C) by hand, turning clockwise until tight.
5. Thread lower pole (B) to base (A) by hand, turning clockwise until tight.
6. If installed, remove socket ring (F) from socket assembly (G).
7. Place shade (E) on socket assembly (G).
8. Secure shade (E) in place by threading socket ring (F) onto socket assembly (G) and firmly tighten by hand.
9. Install bulb following the "Bulb Insertion/Replacement" instructions below.
10. Plug the lamp into a standard 120V outlet.
11. Adjust shade height and angle by turning thumb levers (J, K) counterclockwise to loosen, reposition shade (E), then turn thumb levers (J, K) clockwise to tighten.
12. Turn lamp on or off by rotating the switch (L) located on the socket clockwise.

Step 3: Bulb Insertion/Replacement

1. Make sure the lamp is not plugged into an electrical socket.
2. If the lamp has been in use, allow it to cool for approximately 5 minutes before proceeding.
3. To install a bulb (M) in the socket, grasp the bulb firmly in your hand and push the bulb straight into the socket by applying pressure to the base of the bulb, until it "snaps" into place. Do not apply pressure to the glass end of the bulb.
4. To remove a bulb (M) already installed in the lamp, grasp it firmly in your hand and pull it straight out of the socket. Do not twist or turn the bulb while removing it from the socket.
5. Turn lamp on or off by rotating the switch (L), located on the socket, clockwise.

Please note that in operation, OttLite® bulbs are not dimmable.

Enjoy your OttLite® Marietta Floor lamp!

This lighting system is designed for use with OttLite® Type M tubes (Style Number SB20-M). Use of other products voids the warranty and may result in damage to the lighting system.

⚠️ CAUTION! IMPORTANT SAFETY INSTRUCTIONS:

To prevent electric shock: Match the wide blade of the plug to the wide slot, and fully insert.

This portable lamp has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless the plug can be fully inserted. Do not alter the plug.

⚠️ CAUTION: If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard. Indoor use only.