SÅGMÄSTARE Shelving Unit
Important Information & Safety Warning
Important Information
Read carefully. Follow each step of the instruction carefully. Keep this information for further reference.
⚠️ WARNING: Serious or fatal crushing injuries can occur from furniture tip-over. To prevent this furniture from tipping over, it must be permanently fixed to the wall with the included wall attachment devices.
Fastening devices for the wall are not included since different wall materials require different types of fastening devices. Use fastening devices suitable for the walls in your home. For advice on suitable fastening devices, contact your local specialized dealer.
Parts List
The following parts are included in the package:
- 12x Bolt (Part #10130087)
- 4x Screw (Part #10045513)
- 4x Knob/Cap (Part #10036516)
- 2x Wall bracket clip (Part #10121907)
- 2x Wall bracket base (Part #114664)
- 1x Wall anchor pad (Part #10114785)
Assembly Instructions
Follow these steps carefully to assemble your SÅGMÄSTARE shelving unit.
- Step 1: Prepare Vertical Rods
Attach the knobs (10036516) to the threaded ends of the longer bolts (10130087). Insert the shorter screws (10045513) into the designated holes on the cylindrical rod ends.
- Step 2: Attach Rods to Side Panels
Insert the threaded ends of the assembled rods from Step 1 into the corresponding holes on the side panels.
- Step 3: Connect Panels
Attach the top and bottom panels to the side panels using the assembled rods from Step 2.
- Step 4: Stand Unit Upright
Carefully stand the assembled frame upright.
- Step 5: Insert Shelves
Slide the shelves into their designated positions within the frame.
- Step 6: Attach Top Support Rods
Insert the remaining threaded rods into the top of the unit.
- Step 7: Secure Top Panel
Place the top panel onto the frame and align it with the rods from Step 6.
- Step 8: Fasten Top Panel
Secure the top panel by screwing in the parts (10045513) from the underside.
- Step 9: Position Unit
Move the shelving unit to its final desired location against a wall.
- Step 10: Prepare Wall Mounting Hardware
Place the wall anchor pads (10114785) on the wall where the unit will be secured. Attach the wall bracket bases (114664) to the back of the shelving unit using screws (10045513). Then, attach the wall bracket clips (10121907) to the wall bracket bases.
- Step 11: Secure Unit to Wall
Hook the wall bracket clips (10121907) onto the wall. This step is crucial for preventing tip-over. ⚠️ Ensure the unit is securely fastened to the wall.
- Step 12: Level the Unit
Use a [spirit level] on the top surface. Adjust the feet at the bottom of the unit by turning them until the unit is stable and level.
Final Check
⚠️ IMPORTANT: Always secure the furniture to the wall using the provided wall attachment devices to prevent serious injury from tip-over. Ensure you use appropriate wall fasteners for your specific wall type.
