Orbit 1 Dial 1 Outlet Hose Faucet Timer
Important Information
When expecting freezing temperatures, timers should be removed from the hose faucet and stored indoors to avoid potential freeze damage.
The filter traps dirt particles, prolonging the life of the timer. Clean the filter regularly and replace if worn.
Timer Features
The timer features the following components:
- HOSE TAP CONNECTION: Connects to the hose faucet.
- OUTLET: Where the hose connects.
- FILTER: Traps dirt particles.
- DIAL: Rotates to customize the watering schedule.
- MANUAL Button: Press to water manually.
- DELAY Button: Use to select RAIN DELAY mode.
- CLEAR Button: Press to clear programming.
- RESET Button: Press to clear all programming.
- [+/- buttons]: Use these buttons to adjust time and system setup.
- LOW BATTERY INDICATOR: Notifies when batteries are low.
The dial has several settings:
- OFF: Turns off all watering.
- AUTO: Timer waters according to your customized schedule.
- SET CLOCK: Set the time of day.
- START TIME: Select what time you would like to start watering.
- HOW LONG: Determine how long to water.
- HOW OFTEN: Choose how often you will water.
Installing the Batteries
- Remove the battery tray on the back of the timer by sliding or pulling it out.
- Insert two AA (1.5V) alkaline batteries (not included) and replace the tray.
Note: Firmly replace the battery tray to ensure water resistance and increase battery life. You will know the battery tray is fully inserted if it does not pull out easily. Used up or dead batteries must be removed from the timer and disposed of properly. Replace batteries when the low battery icon appears on the display. Do not dispose of batteries in fire, as they may explode or leak.
Programming the Timer
Set Clock
1. Turn the [dial] to [SET CLOCK].
2. Using the [+/- buttons], set the time of day, including AM and PM. The timer advances faster if a button is held down.
3. Turn the [dial] to save changes.
Start Time
1. Turn the [dial] to [START TIME].
2. Using the [+/- buttons], set your start time, including AM and PM. The timer advances faster if a button is held down.
3. Turn the [dial] to save changes.
How Long
1. Turn the [dial] to [HOW LONG].
2. Using the [+/- buttons], select watering duration from 1 to 360 minutes. The timer advances faster if a button is held down.
3. Press the [CLEAR button] to reset the run time.
4. Turn the [dial] to save changes.
How Often
1. Turn the [dial] to [HOW OFTEN].
2. Using the [+/- buttons], set your watering frequency. You may choose to water every 1 hour, 2 hours, 4 hours, 6 hours, 12 hours, or from 1 to 7 days. Note: '1' means every day, '2' means every other day, etc.
3. Turn the [dial] to save changes.
Congratulations
Your timer is now programmed. Turn your [dial] to [AUTO] to allow your timer to water according to the programmed time, station, duration, and frequency.
Additional Features
Rain Delay
Rain delay allows you to postpone watering for a set period of time. To access the rain delay, follow these steps:
- With the [dial] on [AUTO], press the [DELAY button].
- Using the [+/- buttons], select a delay of 1 to 7 days.
- The screen will flash between the clock and the hours remaining before the programmed cycle resumes.
- To remove rain delay, turn the [dial] to [OFF] and then back to [AUTO].
Manual/Hand Watering
This feature allows you to water without interrupting your set schedule. To access this feature, follow these steps:
- With the [dial] on [AUTO], press the [MANUAL button].
- Use the [+/- buttons] to select watering time from 1 to 360 minutes.
- The screen will flash between the clock and the hours remaining before the programmed cycle resumes.
Note: There may be a slight delay between the time the manual button is pressed and when watering begins.
- To stop manual watering, turn the [dial] to [OFF].
- Turn the [dial] back to [AUTO] to resume your programmed watering schedule.
Troubleshooting
Water does not come on at desired time.
Check if:
- The [clock] is set to the correct time, including AM and PM.
- The [dial] is set to [Auto].
- The [Start time] is set to the desired time, including AM and PM.
- [Rain Delay] is on.
Timer does not water.
Check if:
- The [timer] is set to [AUTO].
- The [hose faucet] is on.
- [Batteries] are low (check for ? or [low battery indicator]).
- The [clock] is set to the correct time, including AM and PM.
- [Rain Delay] is on.
Water won't turn off.
Check if:
- [HOW LONG] is set to the desired time.
- [HOW OFTEN] is set to the desired interval (hour or day).
Working water pressure:
- Minimum: 10 psi
- Maximum: 100 psi
Working temperature:
- Maximum: Do not exceed 120°F (49°C)
- Minimum: Keep from freezing
