Pabobo Aqua Dream Turtle Ocean Projector

Introduction

Thank you for choosing Aqua Dream, the smart solution to getting baby to sleep.

Please read this Instruction Manual carefully before use. In the box you will find:

• An ocean atmosphere projector module
• A plush base for the module
• A USB type C charging cable
• These instructions

First Use / Charging the Product

1. Connect the USB-C cable to the plug on the product.
2. Connect the cable to a USB device, or to a universal charger to recharge directly in the mains. This device must be recharged with an EN 60335-2-29 compliant universal USB 5V charger.
3. The charging indicator LED lights up red when the battery is low and green when energy is full. The indicator stays on when the device is charging and the cable is plugged in.
4. To avoid attracting children to the plug or the computer, the projector does not turn on while charging.
5. To optimize battery life, we suggest charging the module for at least 8 hours for the first use.
6. A fully charged battery (1200 mAh) offers from 2 to 6 weeks of power, depending on your usage.
7. Replace the module in the plush base, making sure that the elastic is properly inserted into the rim. We recommend starting with the front and then following the rim all around to slide the elastic border into place.
8. Your projector is ready to use, it's sleep time!

How to Use (See Diagram)

The projector has several control buttons:

• A. Main button (on-off): Activates the moving projections for 25 minutes, then stops automatically.
• B. Lullaby button: Press once for Lullaby 1, twice for Lullaby 2, and a third time to turn off the sound. Subsequent presses cycle through the lullabies. (Automatic stop after 15 minutes).
• C. Background sound button: Press once for the first ambient sound (waves), twice for white noise, and a third time for heartbeat sound. (Automatic stop after 15 minutes).

Projections and sounds are independent; you can choose projections only, sound only, or both.

Background sounds and lullabies cannot be played together. For example, if a lullaby is playing, activating the wave sound will deactivate the lullaby.

The automatic stop timer (timer) resets with each button press. Any press during operation restarts the music (auto-stop after 15 min) or projections (auto-stop after 25 min).

You can adjust the light intensity (D) through 3 levels (30%, 60%, or 100%) and the sound level (E) through 4 levels by pressing the appropriate buttons successively.

Tip: To reduce battery consumption, use the lowest light intensity and sound level.

For the best effect, place the projector approximately 1.5 meters (about 5 feet) from the ceiling.

Cleaning the Plush Base

• Attention: Before any cleaning, even superficial, remove the plastic module (projector) from the plush base.
• We suggest washing by hand or by machine at 30°C.
• Warning: Do not dry in a dryer.

Guarantee

Remember to keep your proof of purchase; it will be essential to benefit from the Guarantee.

Environment

The battery is not replaceable. The battery must be removed from the device before it is scrapped. The battery must be disposed of safely by opening the module.

Safety Information

• This lamp is not a toy.
• To be used under parental supervision.
• The USB cable should only be handled by an adult. Keep the cable and projector out of reach of children while charging. Keep product and packaging out of reach of children.
• Do not cover the lamp.
• This product is designed for indoor use only and is not water-resistant.
• Always use a clean, dry cloth to clean the device.
• The product and cable should be inspected regularly for any damage. If damaged, it should not be used until repaired.
• In the event of a malfunction, do not attempt to disassemble the product. Contact customer service instead.