JLab JBuds Work Wireless Headphones

Bluetooth Pairing

1. Step 1

   Enable Bluetooth in your device settings.

   [Diagram: Phone settings screen showing Bluetooth enabled]

2. Step 2

   Press the button for 8 seconds. Lights will flash blue/red.

   [Diagram: Headphones with button, showing blue/red flashing lights]

3. Step 3

   Select "JLab JBuds Work" in your device settings to connect.

   [Diagram: Phone settings screen showing connection to "JLab JBuds Work"]

Multipoint (Connect Two Devices Simultaneously)

1. Step 1

   When the FIRST device is connected, turn off Bluetooth in the device settings. JBuds Work will automatically enter Bluetooth pairing mode.

   [Diagram: Phone settings screen]

2. Step 2

   Go to the SECOND device's Bluetooth settings and connect to JBuds Work.

   [Diagram: Headphones connecting to a second device]

3. Step 3

   Go to the FIRST device's settings. Turn Bluetooth on and connect to JBuds Work.

   [Diagram: First device connecting to headphones]

For more information and troubleshooting on MULTIPOINT, visit: INTL.JLAB.COM/MULTIPOINT

Button Functions

• Volume Up: Press once
• Next Track: Press and hold for over 2 seconds
• Volume Down: Press once
• Previous Track: Press and hold for over 2 seconds
• Power On/Off: Press and hold for over 3 seconds
• Play/Pause: Press once
• Answer/End Call: Press once (works when boom microphone is in the down position)
• Reject Incoming Call: Press and hold for over 1 second
• Activate Siri (iOS) or “OK Google” (ANDROID): Double press
• Be Aware (Hear Yourself) On/Off: Triple press
• Bluetooth Pairing: Refer to Bluetooth Pairing section
• Toggle EQ Audio/Music: Press both buttons simultaneously

Boom Microphone

• Answer Call Automatically: Swivel down
• Auto End Call / Reject Incoming Call: Swivel up

Microphone Mute:

• Microphone Mute ON / OFF
• [Diagram: Microphone mute toggle showing OFF state]
• [Diagram: Microphone mute toggle showing ON state]

Mode Indicators:

• [Diagram: Headphones in Mono Mode] Mono Mode
• [Diagram: Headphones in Stereo Mode] Stereo Mode

Charging

Connect to a computer or USB 5V 1A (or less) power source.

Note: JBuds Work can be charged simultaneously while Bluetooth is connected. Power on and connect to your device after charging.

[Diagram: USB cable connecting headphones to power source]

AUX Input

JBuds Work can be used as a wired headset with an AUX cable.

Note: The headphones still use a limited amount of battery for microphone functionality.

[Diagram: AUX cable connecting headphones to a device]

Warnings

• Try to prevent moisture or liquids from entering the earcups.
• Avoid extreme heat, cold, and humidity.
• Do not drop or crush the headphones, do not strain the cable by pulling it quickly or forcefully, and do not bend the cable at a sharp angle.
• Earwax can build up in the earcups, which can degrade sound quality. Carefully remove earwax with a cotton swab or another small tool to improve sound quality.
• If you feel discomfort or pain, try reducing the volume or stop using the headphones for a while.
• If you consistently feel discomfort when using this product, stop using it and consult a doctor.
• We recommend treating your headphones like your favorite sunglasses and keeping them in a safe place when not in use.