JLab JBuds Work Headset

Warranty & Support

All warranty claims are subject to JLab authorization and our sole discretion. Keep your proof of purchase to guarantee your warranty.

Contact us via support@jlab.com or visit intl.jlab.com/contact.

Sign up today at intl.jlab.com/register for product updates, tips, and FAQs.

Bluetooth Pairing

Step 1: Enable Bluetooth (in your device's settings).

Step 2: Press and hold the button for 8 seconds. Release the button. The lights will flash blue/red.

Step 3: Select "JLab JBuds Work" in your device's settings to connect.

Multipoint Connection (Connect 2 Devices Simultaneously)

Step 1: Once the FIRST device is connected, turn off Bluetooth in that device's settings. The JBuds Work will automatically enter Bluetooth pairing mode.

Step 2: Go to your SECOND device's Bluetooth settings and connect to the JBuds Work.

Step 3: Return to your FIRST device's settings. Turn Bluetooth back on and reconnect to the JBuds Work.

For more information and troubleshooting for MULTIPOINT, visit: INTL.JLAB.COM/MULTIPOINT

Button Functions

Volume & Track Control

• Volume Up: Press once.
• Next Track: Press and hold for 2 seconds.
• Volume Down: Press once.
• Previous Track: Press and hold for 2 seconds.

Call & Media Control

• Power On/Off: Press and hold for 3 seconds.
• Play/Pause: Press once.
• Answer/End Call: Press once (works when the boom microphone is flipped down).
• Reject Incoming Call: Press and hold for 1 second.
• Activate Siri (iOS) or "OK Google" (Android): Press twice.
• Sidetone On/Off (during a call): Press three times.
• Bluetooth Pairing: See Bluetooth Pairing section.

EQ Toggle

• Toggle between Voice/Music EQ: Press both buttons simultaneously.

Boom Microphone

• Automatically Answer Call: Flip the boom microphone down.
• Automatically End Call/Reject Incoming Call: Flip the boom microphone up.

Microphone Mute

The diagram indicates mute status with a red circle for 'Mute On' (DEMPEN AAN) and a grey circle for 'Mute Off' (DEMPEN UIT).

Headset Modes

• Mono Mode
• Stereo Mode

Charging

Connect to a 5V 1A USB device (or less).

Note: The JBuds Work can also be charged while Bluetooth is connected. Turn on the device and connect after charging.

Diagram description: Shows a USB cable connecting to a power source and the headset's charging port.

AUX Input

The JBuds Work can be used as a wired headset with an audio cable.

Note: The headset still uses a small amount of battery power to function the microphone.

Diagram description: Shows a standard 3.5mm audio cable connecting the headset to an audio source.

Warnings

• Ensure no moisture or liquids are in the headphone jack.
• Avoid extreme heat, cold, and moisture.
• Prevent dropping or crushing the headset, straining the cable with quick pulls or excessive force, or bending the cable at sharp angles.
• Earwax may accumulate in the headphones, reducing sound quality. Carefully remove earwax with a cotton swab or small object to improve sound quality.
• If you experience discomfort or pain, try lowering the volume or temporarily stop using the product.
• If you regularly experience discomfort while using this product, stop using it and consult a doctor.
• We recommend treating your headphones like sunglasses and storing them in a safe place when not in use.

Resources

Shop Products | Product Notifications | Play Your Headphones

JLab Store + Burn-in Tool