Hykolity LED Mini Wall Pack Light

Product Specifications

Installation Instructions

Cautions

⚠ CAUTIONS

1. DANGER: Risk of shock. Disconnect power before installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical code.
3. Suitable for wet location and operation in ambient not exceeding 40°C.
4. Use minimum 75°C supply conductors.
5. Products are not intended for use in environments containing airborne corrosive agents such as chemical solvents, cleaners, or cutting fluids.
6. This luminaire is rated for 120Vac 60Hz only.
7. Replace the lens if damaged.

Installation Steps

1. Remove the lens by removing the 2 screws securing it to the rear housing and set aside.

   Diagram 1: Shows a side view of the light fixture with a screwdriver removing two screws from the front lens.

2. Loosen two screws enough to allow the reflector to slide upward until the keyhole in the reflector releases from the two screws. Remove reflector.

   Diagram 2: Shows the fixture with the lens removed, and a screwdriver loosening screws to detach the reflector.

   Diagram 3: Shows the internal components of the fixture after the reflector has been removed.

3. Knock out appropriate holes around the outlet hole in the rear housing and apply the gasket to the back surface of the housing. Fasten the rear housing to the outlet box using the screws supplied with the outlet box.

   Diagram 4: Shows the rear of the fixture with knockouts being made and the gasket being applied.

4. Complete the wiring to the power source and ground, making the following electrical connections in the mounting box or junction box:
   1. Connect the black lead to the voltage supply lead.
   2. Connect the white lead to the neutral supply lead.
   3. Connect the ground lead to the supply ground lead.
   4. To ensure a rain-tight seal, apply silicone caulking around the back edges of the fixture.

   Diagram 5: Shows the fixture mounted to a wall surface, with wires being connected.

5. Replace reflector.

   Diagram 6: Shows the final assembly with the front housing being attached.

6. Replace front housing by reversing the procedure used to remove it.

Support

Thank you for ordering our product. If you have any issue, please email it and your order ID to inquiry@hykolity.com or call +1 (562) 456-0507.