Foxeer Reaper Extreme VTX
Product Overview and Technical Specifications
Specifications
- Size: 66*37*16mm
- Connector: SMA
- Display: 3 LEDs
- Weight: 48g
- Power Output: 1W, 2.5W, 5W, 7.5W, 10W
- Input Voltage: 9~36V
- Output Voltage: 5V
- Channels: 80CH
- Remote Control Protocol: Tramp
LED Indicator Description
| LED | Description |
|---|---|
| Red LED | Power |
| Green LED | Channel |
| Blue LED | Band |
Button Operation
The VTX features a single button for control. Different press durations and sequences access various settings:
- Channel Select Mode: A short press enters channel setup. The green LED will flash. Select channels using subsequent short presses.
- Band Select Mode: Press and hold the button for 3 seconds. The blue LED will flash. Select bands using short presses.
- Power Select Mode: Press and hold the button for 3 seconds (after band select or from idle). The red LED will flash. Select power levels using short presses.
Frequency Table
The following table details the frequencies (in MHz) for each band and channel:
| Band | CH1 | CH2 | CH3 | CH4 | CH5 | CH6 | CH7 | CH8 |
|---|---|---|---|---|---|---|---|---|
| A | 5865 | 5845 | 5825 | 5805 | 5785 | 5765 | 5745 | 5725 |
| B | 5733 | 5752 | 5771 | 5790 | 5809 | 5828 | 5847 | 5866 |
| E | 5705 | 5685 | 5665 | 5645 | 5885 | 5905 | 5925 | 5945 |
| F | 5740 | 5760 | 5780 | 5800 | 5820 | 5840 | 5860 | 5880 |
| R | 5658 | 5695 | 5732 | 5769 | 5806 | 5843 | 5880 | 5917 |
| H | 5653 | 5693 | 5733 | 5773 | 5813 | 5853 | 5893 | 5933 |
| L | 5333 | 5373 | 5413 | 5453 | 5493 | 5533 | 5573 | 5613 |
| U | 5325 | 5348 | 5366 | 5384 | 5402 | 5420 | 5438 | 5456 |
| O | 5474 | 5492 | 5510 | 5528 | 5546 | 5564 | 5582 | 5600 |
| X | 4990 | 5020 | 5050 | 5080 | 5110 | 5140 | 5170 | 5200 |
The table also lists power levels: PIT, 1W, 2.5W, 5W, 7.5W, 10W.
Frequency and Power Unlock
To unlock all frequencies and power levels:
Long press the "KEY" button until the Red LED (PWR) turns on, then off, then on again. Release the button. A flashing Red LED indicates the unlocked status; a constant Red LED indicates the locked status.
PIT Mode On/Off
To activate or deactivate PIT Mode:
Double-click the "KEY" button. When the Red LED (PWR) is off, PIT Mode is active, outputting extremely low power. When the Red LED (PWR) is on, PIT Mode is off.
Notes
If the Tramp cable is connected, the button controls will not function, and frequency/power adjustments will be managed by the flight controller.
