Beldray Spin Mop User Manual

Description of Parts

The Beldray Spin Mop consists of the following components:

• 1. Mop bucket with wringer
• 2. Mop head
• 3. Microfibre head (quantity: 2)
• 4. Pole with handle
• 5. Pole
• 6. Pole
• 7. Locking mechanism
• 8. Dry wringer
• 9. Wash wringer

Assembling the Spin Mop

Before first use, remove all packaging from the components. To assemble the handle, remove the poles and mop head from the bucket.

1. Insert the pole with the locking mechanism attached (6) into the mop head (2) and twist clockwise until secure.
2. Take both poles (5 & 6) and insert them into each other, twisting clockwise until secure.
3. Take the combined poles (5 & 6) and insert into the free end of pole (4), twisting clockwise until secure.
4. To assemble the microfibre head (3), insert it into the mop head (2) until it clicks and is fully secure.

Using the Spin Mop

1. Fill the mop bucket with warm water. Do not overfill above the bottom of the dry wringer. Use only the recommended amount of detergent or disinfectant according to the manufacturer's instructions.
2. Using the carry handles, move the mop bucket to the desired location and place it on an even surface.
3. Before wringing, ensure the mop head is unlocked for the spin function to work. To unlock, flip down the locking mechanism (7) until it unclips. Flip up and click to lock the mechanism.
4. Take the assembled mop and plunge it into the water in the mop bucket.
5. To wring out the microfibre head, push down on the mop handle, causing the mop head to spin. Repeatedly push down until the microfibre head is sufficiently wrung, then proceed to mop the floor surface.
6. Repeat the plunging and wringing process as required.

Note: The mop will not spin unless the locking mechanism (7) has been unlocked. The wash wringer (8) is for spinning the mop head clean, and the dry wringer (9) is for spinning the mop head dry.

Caution: Do not fill the bucket with hot or boiling water. Use only on cool surfaces. Keep out of reach of children. Not suitable for use with bleach.

Changing the Mop Head

1. Place the mop head on the ground with the microfibre head facing downwards.
2. Stand on the microfibres of the microfibre head near its centre to hold it in position while pulling the mop head away until it clicks.
3. Replace the microfibre head by inserting it back into the mop head until it clicks and is fully secure.

Manufacturer Information

Manufactured by:

Ultimate Products UK Ltd., Victoria Street, Manchester OL9 0DD. UK.

Ultimate Products Europe Ltd., 19 Baggot Street Lower, Dublin D02 X658. ROI.

MADE IN CHINA.

Beldray trademark. All rights reserved.

Document Reference: CD180625/MD000000/V1