Beldray Spin Mop User Manual

Product Overview

This user manual provides instructions for the Beldray Spin Mop, a household cleaning tool designed for efficient floor cleaning.

Important Safety Information:

• Do not fill the bucket with hot or boiling water.
• Use only on cool surfaces.
• Keep out of the reach of children.
• Not suitable for use with bleach.

Parts Description

The Beldray Spin Mop includes the following components:

• 1. Mop bucket with wringer
• 2. Pole
• 3. Pole
• 4. Pole
• 5. Locking cap
• 6. Mop head
• 7. Microfibre head (quantity: 2)
• 8. Wringing pedal

Assembling the Mop

Before first use, remove all packaging from the components.

1. Unscrew the locking cap (5) from the mop head (6) by twisting it anticlockwise.
2. Insert the small end of pole (4) into the mop head (6) and tighten the locking cap (5) clockwise until the pole is secure.
3. Take pole (2) and insert into pole (3), twisting clockwise until secure.
4. Take the combined poles (2 & 3) and insert into the free end of pole (4), twisting clockwise until the pole is secure.
5. To assemble the microfibre head, insert it into the mop head until it clicks and is fully secure.

Using the Spin Mop

1. Fill the mop bucket with warm water. Do not overfill above the bottom of the wringing basket. Use only the recommended amount of detergent or disinfectant according to the manufacturer's instructions.
2. Using the carry handle, move the mop bucket to the desired location and place it on an even surface.
3. Take the assembled mop and plunge it into the water in the mop bucket. Once wet, place the mop head into the wringing basket, ensuring the entire mop head fits in.
4. To wring out the microfibre head, push down on the pedal, which will cause the mop head to spin. Repeatedly push down on the pedal until the microfibre head is sufficiently wrung, then proceed to mop the floor surface.
5. Repeat the plunging and wringing process as required.

Changing the Mop Head

1. Place the mop head on the ground with the microfibre head facing downwards.
2. Stand on the microfibres of the microfibre head near its centre to hold it in position while pulling the mop head away until it clicks.
3. Replace the microfibre head by inserting it back into the mop head until it clicks and is fully secure.