Beldray Spin Mop User Manual

Assembling the Mop

Before first use, remove all packaging from the components. To assemble the mop, remove the poles (8 & 10), handle (11), and mop head (12) from the mop bucket (1).

1. Step 1: Insert the small end of the lower pole (8) into the mop head (12) and tighten by twisting in a clockwise direction until the pole is secure.
2. Step 2: Insert the small end of the upper pole (10) into the lower pole (8), twisting in a clockwise direction until secure.
3. Step 3: Insert the small end of the handle (11) into the upper pole (10), twisting in a clockwise direction until the pole is secure.
4. Step 4: To assemble the microfibre head (13), place it onto the mop head (12) and push down to secure.

Directions for Use

Diagram Description: The spin mop system includes a mop bucket with a built-in spinner, a mop handle composed of lower and upper poles, a handle grip, and a mop head with replaceable microfibre heads. The bucket has a filling hole, a plug for draining, and a clear lid. A fixing lever on the handle is used to secure the mop's length. Bristles are present within the spinner mechanism.

1. Step 1: Fill the inner compartment by adding warm water to the filling hole. Do not overfill the inner compartment. Use only the recommended amount of detergent or disinfectant, according to the manufacturer's instructions.
2. Step 2: Ensure the clear lid is securely fitted onto the inner compartment.
3. Step 3: Using the carry handle, move the mop bucket to the desired location and place it on an even surface.
4. Step 4: Take the assembled mop and release the fixing lever, allowing the mop to extend.
5. Step 5: Place the mop head into the mop bucket, ensuring the centre aligns and the mop head fits onto the spinner.
6. Step 6: Whilst firmly gripping the mop handle, push down repeatedly to spin the mop head and wet the microfibre head with water from the inner compartment.
7. Step 7: Remove the mop from the bucket and secure the fixing lever to lock the mop handle into place.
8. Step 8: Proceed to mop the floor with the wet microfibre head.
9. Step 9: To remove dirty water and refresh the microfibre head with clean water, repeat steps 4-7. The bristles will remove dirty water as the mop head spins, and this will collect in the mop bucket, keeping it separate from the clean water in the inner compartment.
10. Step 10: Repeat the rinsing and wringing process as required.
11. Step 11: To empty the dirty water, remove the plug from the bottom of the bucket.

Cautionary Notes

CAUTION: Do not fill the bucket with hot or boiling water. Do not overfill the bucket. Use only on cool surfaces. Keep out of the reach of children. Not suitable for use with bleach.

Changing the Mop Head

1. Step 1: To remove the microfibre head, hold the mop head firmly while pulling away the microfibre head until it detaches.
2. Step 2: To replace the microfibre head, place it onto the mop head and push down to secure.