AeroCool Designer Mid Tower Case Installation Guide

Front I/O Cable Connection

Connect the front panel I/O cables to the motherboard. Please refer to the motherboard's manual for detailed instructions.

Note: Specifications may vary by region. Contact your local retailer for more information.

Front Panel Connectors:

• POWER SW (Power Switch)
• RESET SW (Reset Switch)
• H.D.D LED (Hard Drive Activity LED)
• POWER LED (Power LED)
• USB3.0
• HD AUDIO

Accessory Bag Contents

• 18 x SSD Screw
• 9 x MB Screw
• 6 x HDD Screw
• 3 x PSU Screw
• 5 x PCI Screw
• 3 x MB Standoff
• 8 x Fan Screw
• 5 x Cable Tie

Installation Steps

1. Step 1: Install Motherboard

   Mount the motherboard onto the standoffs inside the case.

2. Step 2: Install PSU

   Install the Power Supply Unit (PSU) into its designated bay.

3. Step 3: Install Add-on Card

   Install expansion cards (e.g., graphics card) into the appropriate PCI-e slots.

4. Step 4: Install 3.5" HDD

   Slide the 3.5" Hard Disk Drive into the drive bay and secure it.

5. Step 5: Install 2.5" SSD

   Slide the 2.5" Solid State Drive into the drive bay and secure it.

6. Step 6: Install Front Fan

   Install a 120mm fan at the front of the case for intake airflow.

7. Step 7: Install Top Fans

   Install 120mm fans at the top of the case for exhaust airflow.

8. Step 8: Install Rear Fan

   Install a 120mm or 140mm fan at the rear of the case for exhaust airflow.

9. Step 9: Install Bottom Fan

   Install a fan in the PSU shroud area for additional airflow.

10. Step 10: Install Front Radiator

    Mount a radiator (120mm, 240mm, or 360mm) at the front of the case.

11. Step 11: Install Rear Radiator

    Mount a 120mm radiator at the rear of the case.

12. Step 12: I/O Panel Connections

    Connect the front panel I/O cables: Power, USB 2.0, HD Audio, Reset, Microphone, USB 3.0.

    LED Control Button:

    • Hold the LED control button for 3 seconds to switch between motherboard and button control.
    • Hold the LED control button for 6 seconds to turn off LED, press once to turn it back on.

    Note: For more information on connecting ARGB components, visit aerocool.io.

ARGB Version: RGB Fan Hub Connection Guide

This section details connecting RGB components for the ARGB version of the case.

For ASUS Aura Sync, MSI Mystic Light Sync, and GIGABYTE RGB Fusion Motherboards:

• Connect component (A) to the motherboard's PWM socket.
• Connect component (B) to the motherboard's Addressable RGB socket.
• Connect component (C) to the PSU's SATA connector.

For Non-Addressable RGB Motherboards:

• Connect component (A) to the motherboard's PWM socket.
• Connect the 2-Pin LED button connector (E) to your RGB hub.
• Connect component (C) to the PSU's SATA connector.

Use the RGB fan connectors (F) to connect Addressable RGB fans to your hub.

Recycling Information (France)

This device is recyclable. Return it at delivery or deposit it in collection points. Find collection points at www.quefairedemesdechets.fr. Prioritize repair or donation of your device!