Front I/O Panel Cable Connection
Front Panel Connector
Please refer to the motherboard's manual for further instructions.
Note: Specifications may vary depending on your region. Contact your local retailer for more information.
Connectors:
- POWER SW (Power Switch)
- RESET SW (Reset Switch)
- HDD LED ± (Hard Drive Activity LED)
- POWER LED + / - (Power LED)
Internal Connectors:
- HD AUDIO
- USB
- USB 3.0
- Card Reader
- F-PANEL (Front Panel Header)
Diagram shows pin assignments for these connectors.
Accessory Bag Contents
The accessory bag typically contains the following items:
- 1: SSD Screw, MB Screw
- 2: PSU Screw, PCI Screw, HDD Screw
- 3: Fan Screw
- 4: MB Standoff, Cable tie
Diagram illustrates these components.
How to Install Guide
Step 1: Install Motherboard
This step involves mounting the motherboard into the PC case. Ensure proper alignment with standoffs.
Diagram shows a motherboard being placed onto the standoffs inside the PC case chassis.
Step 2: Install PSU
Mount the Power Supply Unit (PSU) into its designated bay within the case.
Diagram shows a power supply unit being slid into its mounting bracket at the bottom of the case and secured with screws.
Step 3: Install Add-on Card
Install expansion cards such as graphics cards or network cards into the appropriate PCI-e slots on the motherboard.
Diagram shows an expansion card (like a GPU) being inserted into a PCI-e slot on the motherboard.
Step 4: Install 3.5" HDD x 2
Install up to two 3.5-inch Hard Disk Drives (HDDs) into the drive cages within the case.
Diagram illustrates the installation of 3.5-inch HDDs into the drive cages.
Step 5: Install 2.5" SSD
Install 2.5-inch Solid State Drives (SSDs) into their designated mounting points. The case supports multiple SSD installations (e.g., 2.5" SSD x 2, 2.5" SSD x 1).
Diagrams illustrate the installation of 2.5-inch SSDs in various configurations and locations.
Step 6: Install Front Radiator
Install a radiator (up to 1x) at the front of the case for cooling. This may involve mounting fans as well.
Diagram shows a liquid cooling radiator being mounted to the front of the case, with fans potentially attached.
Step 7: Install Fans
Install fans into the front, rear, and potentially side or top locations for optimal airflow. The guide shows options for front fan, rear fan, and VGA fan installation.
Diagrams illustrate fan installations for the front, rear, and VGA areas.
I/O Panel
The rear I/O panel provides the following connections:
- Power
- HD Audio & Mic
- USB 2.0
- USB 3.0
- Reset
- Card Reader (SD/TF slots)
Note: Specifications may vary depending on your region. Contact your local retailer for more information.
