Momcozy Portable Breast Pump

Installation Guidelines

Ensure your hands are clean before starting installation.

1. Attach the diaphragm and valve to the connector. Align the "ear" with the groove.
2. Attach the assembled connector to the milk collector.
3. Attach the flange to the milk collector.
4. Assemble the pump and milk collector.

Pouring Milk

Hold the milk collector in the correct direction when pouring milk.

Troubleshooting

If any product issues arise during installation or your pumping session, refer to the troubleshooting video for further solutions. Open the troubleshooting video by scanning the QR code.

How to Prevent Milk Leaks and Pumping Tips for More Milk Production

1. Lean forward to ensure your nipple is centered in the flange tunnel. The breast pump should sit snugly against your breast.
2. We recommend users wear a full-coverage nursing bra to create a tight seal between the breast and flange.
3. Ensure the pump is assembled correctly.
4. When pumping, sit or stand upright; do not lie down.

Cleaning and Sterilization

Non-washable parts:

• Pump Motor

Washable parts:

• Milk Collector
• Flange
• Diaphragm
• Connector
• Valve

We recommend using soapy water (40-60°C) to clean washable parts for 3-5 minutes.

Use boiling water/steam/sterilizing pot for sterilization, at a temperature below 100°C (212°F). Boil and sterilize parts for 5-10 minutes.

It is recommended not to sterilize your breast pump accessories in a microwave, as this shortens the lifespan of the accessories.

Tips

• The expected lifespan for washable parts is one to three months. It is recommended to replace washable parts after long-term storage or before pumping for your next child.
• The breast pump will automatically shut off after 30 minutes of pumping. If irritation or discomfort occurs, discontinue use and consult a healthcare provider.