IVER™ POSI-TEMP® with Built-In 3 Function Transfer Valve Trim
Product Identification
Models: T2570 Series
Compatible Valves: 2521, 2551, 2571, 2581
Note: Refer to the valve specification sheet for precise cutout dimensions.
General Description
- Metal construction with various finishes available, indicated by suffix.
Operational Features
- Handle travel operates through a 270° arc, covering full cold to full hot water ranges.
- Includes an adjustable temperature limit stop to regulate maximum hot water temperature.
- The transfer valve handle rotates 90° and features stops.
- A pressure balancing mechanism maintains the selected discharge temperature within ± 3°.
Standards and Compliance
- Certified by a third party to ASME A112.18.1/CSA B125.1 standards.
- Complies with ADA requirements for lever handles.
Warranty Information
- Lifetime limited warranty covering leaks, drips, and finish defects for the original homeowner.
- 10-year limited warranty for installations in multifamily properties.
- 5-year limited warranty for installations in commercial properties.
For comprehensive details and limitations, please visit www.moen.com/support.
Installation Dimensions and Diagrams
The following details the physical dimensions and installation configurations:
Trim Plate Dimensions
The trim plate itself measures 6-1/4 inches (160mm) in width and 10-1/4 inches (260mm) in height.
Valve Mechanism Installation
Two primary installation scenarios are depicted based on wall thickness:
- Scenario 1: Wall Thickness Greater Than 1/4 Inch
The valve body is positioned 2-3/4 inches (70mm) from the finished wall line. The water inlet is located 3-1/8 inches (80mm) from the wall line and 2 inches (50mm) from the valve body. The floor level is shown 1-5/8 inches (42mm) below the valve body.
- Scenario 2: Wall Thickness Less Than 1/4 Inch
This configuration is suitable for installations with a plastic tub/shower surround, which is approximately 3/16 inch (5mm) thick.
