Parts List
| Item | Qty | Description | Item | Qty | Description |
|---|---|---|---|---|---|
| A | 1 | Crossmember | C | 2 | M16 x 50 Bolts, Nuts & S/P Washers |
| B | 1 | Extension Bar | D | 2 | M12 x 85 Grade 10.9 Bolts & Nyloc Nuts |
| E | 4 | M10 x 30 Bolts & S/P Washers | |||
| F | 4 | 10 x 25 Flat Washers | |||
| G | 4 | 12 x 25 Flat Washers |
Installation Steps
- Remove the rear bumper. Fixings securing mud flaps if fitted, one fixing behind wheel arch liner, two push fixings inside each wheel arch, fixings along lower edge (on some models this may be fixed to under tray), one fixing inside by light in bumper and two fixings on boot shut panel. Disconnect light in bumper.
- Lower the exhaust with its hangers at the rearmost point and support to prevent damage and remove heat shield.
- Remove the bumper impact beam and discard the steel back plate.
- Locate all towbar mounting points and remove any mastic from mating faces.
- Position Item A into chassis openings and loosely bolt in place with Item E and Item F.
- Using original fixings bolt the impact beam and Item A to the back panel.
- If fitted cut the under tray to suit towbar.
- Fully tighten all nuts and bolts and ensure towbar is rigid and secure.
- Refit heat shield and exhaust hangers.
- Refit bumper.
Diagram Description
The diagram illustrates the Tow-Trust TBM908 towbar assembly for the MINI HATCH (BMW) 2001-2006. It shows the main crossmember (Item A) and extension bars (Item B) being attached to the vehicle's chassis at designated mounting points, marked with 'X'. The diagram also indicates the use of various bolts (Items C, D, E) and washers (Items F, G) for securing the towbar components to the vehicle structure. Specific connection points and the general layout of the towbar relative to the vehicle's rear are depicted.
Notes
- Recommended Torque Setting for M12 Grade 10.9: 109 - 139 Nm. (For other Torque Settings see notes overleaf.)
- Nose load limits and vehicle manufacturers trailer / caravan weight limits must be observed.
