DOD Mini Volume Pedal Owner's Manual

Introduction

Thank you for purchasing the DOD Mini Volume Pedal. This compact, passive volume pedal offers a full range of volume control without sacrificing valuable space on your pedalboard.

Features

• Compact size minimizes pedalboard footprint
• Full-size treadle for complete control
• High-quality 500 kΩ potentiometer for smooth volume adjustments
• Built-in treble bleed circuit prevents high-frequency loss at lower volume settings
• Removable rubber feet for pedal mounting
• 1/4" TS input and output connectors
• Non-slip treadle surface
• Rugged construction

Setup

1. Turn off your amplifier and connect the cables (refer to the connection diagram below).
2. Turn down your amplifier's volume, press the DOD Mini Volume Pedal treadle down, and then turn on the amplifier.
3. Slowly increase the amplifier's volume until you reach your desired level.

Connection Diagram Description

The diagram illustrates a typical guitar signal chain: Guitar -> Effect Pedals (including the DOD Mini Volume Pedal) -> Amplifier. It emphasizes the use of unbalanced TS cables for all connections.

USE ONLY UNBALANCED TS CABLES

Important Usage Notes

Two hex screws on the bottom of the pedal adjust the spring-loaded treadle mechanism. If the treadle becomes loose over time, slightly loosen these screws and then retighten them. This will re-engage the main drive gear with the treadle mechanism. Do not remove these screws or tamper with the pedal while they are loosened, as this may cause gear misalignment and pedal malfunction. The pedal contains no user-serviceable parts and should never be opened.

Safety and Compliance Instructions

The following symbols are internationally recognized warnings for electrical products:

• ⚡ (Lightning bolt in a triangle): Indicates hazardous voltage within the unit.
• ! (Exclamation mark in a triangle): Indicates that the user should read the operating manual.

These symbols indicate that there are no user-serviceable parts inside. Do not open the unit. Do not attempt to service the unit yourself; all servicing should be referred to qualified personnel. Opening the chassis for any reason will void the manufacturer's warranty. Do not expose the unit to moisture. If liquid is spilled on the unit, turn it off immediately and take it for service. Disconnect the unit during lightning storms to prevent damage.

This product is not intended for use above 2000 meters altitude.

UK Plug Warning (General Safety)

A molded mains plug that has been cut off from the cord is unsafe. Dispose of it immediately in a suitable disposal facility. Never insert a damaged or cut mains plug into a 13-amp socket. Ensure the fuse cover is in place. Replacement fuses should be 13 amp and ASTA approved to BS1362.

Disposal Information

Do not dispose of this product with general household waste. Separate collection systems exist for used electronic products in accordance with legislation requiring proper treatment, recovery, and recycling. Households in EU member states, Switzerland, and Norway can return used electronic products free of charge to designated collection facilities or to a retailer if purchasing a similar new product. For countries not listed, contact local authorities for disposal information. This ensures the product undergoes necessary processing, recovery, and recycling, preventing potential negative impacts on the environment and human health.

General Safety Precautions

• Read and save these instructions.
• Heed all warnings.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• For indoor use only.
• Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• Only use accessories/attachments specified by the manufacturer.
• Unplug this apparatus during lightning storms or when unused for long periods.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or third prong are for your safety. If the provided plug does not fit your outlet, consult an electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
• Use only with a cart, stand, tripod bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

Servicing

Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as when the power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

Power Switch

The power switch used in this apparatus does not disconnect the unit from the mains when switched off. To disconnect power, the plug must be pulled from the mains socket. The plug must remain readily accessible.

Wiring Information

For customers in North America, this unit may require the use of other types of connecting cables, plug adapters, or converters depending on the installation site. If the power cord needs replacement, consult qualified service personnel. The green/yellow wire connects directly to the chassis.

Power Cord Wire Identification:

The wires in the mains lead are colored in accordance with the following code:

• Green and Yellow: Earth (Ground)
• Blue: Neutral
• Brown: Live

WARNING: IF THE EARTHING IS IN ANY WAY DEFICIENT, CERTAIN FAULT CONDITIONS IN THE UNIT OR THE SYSTEM TO WHICH IT IS CONNECTED COULD CAUSE THE MAINS VOLTAGE TO BE PRESENT ON THE CHASSIS. IF YOU SIMULTANEOUSLY TOUCH THE CHASSIS AND GROUND, IT MAY RESULT IN SERIOUS INJURY OR DEATH.