Tools and Preparation
Before you begin, ensure you have the following tools:
- Screwdriver
- Hammer
- Spirit Level
Please note the following:
- Do not assemble on a soft or uneven surface.
- Ensure all parts are present before starting.
- Follow each step carefully.
Parts List
The following parts are included:
- Long screws (8x) - Part numbers: 104321, 104322
- Short screws (4x) - Part number: 100372
- Wooden dowels (10x) - Part number: 101339
- Wall bracket (2x) - Part number: 103693
- Hex key (1x) - Part number: 100092
- Plastic connector/bracket (1x) - Part number: 121030
- Hexagonal connectors (2x) - Part numbers: 10002300, 10050334
- Small hexagonal connectors (2x) - Part number: 115753
- Other parts shown: 115754, 118673, 118225, 119509
Assembly Steps
Step 1
Attach the first side panel to the base panel. Insert two long screws (104321/104322) through the pre-drilled holes in the base panel into the side panel. Tighten using the hex key (100092).
Step 2
Insert ten wooden dowels (101339) into the designated holes on the edges of the side and shelf panels. Tap gently with a hammer if needed.
Step 3
Attach the middle shelf panel. Align the dowels on the shelf panel with the corresponding holes on the side panel and push into place. Secure with two long screws (101339) from the outside of the side panel.
Step 4
Attach the second side panel. Align the dowels on the middle shelf and base panel with the holes on the second side panel and push into place. Secure with two long screws (101339) from the outside of the side panel.
Step 5
Slide the back panel into the grooves on the side and shelf panels. Ensure it is fully seated.
Step 6
Attach the top panel. Align the dowels on the top panel with the corresponding holes on the side panels and push into place. Secure with four long screws (101339) from the top panel into the side panels.
Step 7
Insert the remaining shelf panels. Align the dowels and push into place. Secure with four short screws (100372) from the outside of the side panels into the shelf panels.
Step 8
Attach the final front panel. Align the dowels and push into place. Secure with six long screws (104321/104322) from the outside of the side panels into the front panel.
Step 9: Wall Attachment Preparation
Attach the two wall brackets (103693) to the top rear edge of the shelf unit. Use two small hexagonal connectors (115753) for each bracket, screwing them into the pre-drilled holes.
Step 10: Positioning and Leveling
Place the assembled shelf unit in its desired location against the wall. Use a spirit level to ensure the unit is perfectly horizontal.
Step 11: Marking the Wall
With the unit in place and level, mark the wall through the holes in the wall brackets. This indicates where to drill for the wall fixings.
Step 12: Securing to the Wall
Remove the shelf unit from the wall temporarily. Drill holes at the marked locations and insert appropriate wall plugs (not included). Secure the wall brackets to the wall using suitable screws (not included). Ensure the screws and plugs are appropriate for your wall type.
Step 13: Final Assembly
Carefully slide the shelf unit back into position, aligning the wall brackets on the unit with the wall fixings. Ensure it is securely attached.
