Hooke Road Side Guards Installation Instructions
Model: BXG.7203-S
ATTENTION
Please verify all parts are present and read instructions carefully before starting installation. Please feel free to contact your distributor if you have any kind of question about your purchase.
CONTENTS
A1&A2: Side Guards
B1&B2: Front Brackets
C1&C2: Rear Brackets
| Qty | Part Name | Size(mm) | Picture |
|---|---|---|---|
| 9 | Hex Bolt | M8×25 | [Hex Bolt] |
| 16 | Split Lock Washer | D8 | [Split Lock Washer] |
| 16 | Flat Washer | M8×20×2 | [Flat Washer] |
| 4 | Flat Washer | M8×50×2 | [Flat Washer] |
| 8 | Flange Lock Nut | M8 | [Flange Lock Nut] |
Mounting Bracket with Pin “1” x4
Mounting Bracket with Pin “2” x4
TOOLS REQUIRED
- Drive Socket Ratchet Wrench
- 13mm Deep Socket
- 13mm Wrench
To view online instruction, please scan the QR code. [QR Code]
INSTALLATION INSTRUCTION
Driver Side Installation
Remove the factory guards. Find the factory installation holes.
[Image of vehicle side with factory guards removed and installation holes highlighted]
[Image showing the underside of the vehicle with factory mounting points indicated]
[Image showing the vehicle side with numbered areas for bracket installation]
[Close-up image of mounting points labeled '1' and '2']
Step 2
Secure the front mounting brackets to the side guard. Do not fully tighten to allow adjustability.
Use: (2) M8×25 Hex Bolts, (2) D8 Split Lock Washers, (2) M8×20×2 Flat Washers.
[Diagram showing bracket attachment to side guard with hardware]
Step 3
Secure the front mounting brackets to the side guard. Do not fully tighten to allow adjustability.
Use: (2) M8×25 Hex Bolts, (2) D8 Split Lock Washers, (2) M8×20×2 Flat Washers.
[Diagram showing bracket attachment to side guard with hardware]
Step 4
Place the pin “1” & “2” into the factory mounting holes.
Use: (2) Mounting Brackets with Pins “1”, (2) Mounting Brackets with Pins “2”.
[Image showing bracket with Pin '1' inserted into factory hole]
[Image showing bracket with Pin '2' inserted into factory hole]
Step 5
Secure the side guard to your vehicle. Tighten all bolts.
Use: (4) D8 Split Lock Washers, (4) M8×20×2 Flat Washers, (4) D8 Flange Lock Nuts.
[Image showing side guard secured to vehicle with hardware]
[Close-up image of secured mounting point]
Step 6
Repeat this step on the passenger side of your vehicle.
Step 7
The installation is complete. We hope you enjoy a wonderful off-road life with this quality Hooke Road product!
[Image of Hooke Road Side Guards installed on a vehicle]
