Hooke Road

Step 1: Locate Factory Holes

Find the factory installation holes on the driver's side of the vehicle's undercarriage.

Diagram Description: A photograph shows the driver's side of a white SUV. Yellow boxes highlight the lower body panels where the side guards will be installed. Below, close-up views of the vehicle's undercarriage reveal factory-provided mounting holes.

Step 2: Insert Mounting Pins

Place the mounting brackets with pins ('Pin 1' and 'Pin 2') into the corresponding factory mounting holes.

Diagram Description: Close-up views of the vehicle's undercarriage. Mounting brackets, identified as 'Pin 1' and 'Pin 2', are shown being inserted into the factory mounting holes. Arrows indicate the direction of insertion.

Step 3: Secure Brackets to Vehicle

Attach the front and rear mounting brackets to the vehicle's frame using the provided hardware. Tighten all bolts securely.

Hardware: (4) M8x20x1.5 Flat Washers, (4) M8 Split Lock Washers, (4) M8 Flange Lock Nut.

Diagram Description: Close-up views of the vehicle's undercarriage with the front and rear mounting brackets attached. Bolts, washers, and nuts are shown securing the brackets to the vehicle frame.

Step 4: Attach Side Guards to Brackets

Secure the front mounting brackets to the side guard. Do not fully tighten at this stage to allow for adjustability.

Hardware: (4) M8x20 Hex Bolts, (4) M8 Split Lock Washers, (4) M8x20x1.5 Flat Washers.

Diagram Description: Diagrams illustrate the attachment of the side guard to the front mounting bracket using bolts and washers. A second diagram shows the side guard being attached to the rear bracket.

Step 5: Repeat for Passenger Side

Repeat all installation steps on the passenger side of the vehicle.

Step 6: Installation Complete

The installation is complete. Enjoy your off-road life with this quality Hooke Road product!