TL239 Range Rover 1994 - 2002
This guide provides instructions for fitting the Tow-Trust TL239 towbar to a Range Rover (1994-2002 models). Ensure all parts are present before commencing installation.
Parts List
| Item | Qty | Description | Item | Qty | Description |
|---|---|---|---|---|---|
| A | 1 | Crossmember | D | 2 | M16 x 50 Bolts, Nuts & S/P Washers |
| B | 1 | Bracing Stay | E | 8 | M10 x 90 Bolts, Nuts & S/P Washers |
| C | 4 | 22 x 58 Spacer Tubes | F | 2 | M12 x 35 Bolts, Nuts & S/P Washers |
| G | 8 | 10 x 30 Flat Washers | |||
| H | 2 | 12 x 25 Flat Washers |
Fitting Instructions
- Remove the bumper. (Torx bolts each side, push the clips up at each tip slide mounting points and remove the screws securing the mudguards).
- Using item E with item C, loosely bolt item A to the inside of the existing mounting points each side. Place the bolts (item E) into position from the underside, with item G above the mounting points.
- Using item F with item H loosely bolt item B to item A. Using item E, bolt item B to the four existing holes in the chassis member.
- Using item D bolt the ball bracket and wiring plate (not supplied in this kit) to the mounting plate.
- Fully tighten all nuts and bolts and ensure the towbar is rigid and secure.
- Replace the rear bumper.
Diagram
Refer to the provided diagrams for visual guidance on the assembly and placement of components.
Note: nose load limits and vehicle manufacturers trailer / caravan weight limits must be observed.
