Falcon Ridge
Kawasaki KRX1000 Windshield Installation and Care
Model: KAW-KRX-WD02
Important Notices
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab Material is flammable.
NOTICE: Please check contents of package for any damage and ensure all parts fit correctly and you are satisfied with the product before removing the protective film. Once the film is removed, the windshield is not eligible for a full refund.
Preparation and Parts Check
1. Read these instructions thoroughly before opening and installing the Kawasaki KRX1000 Windshield. The roof or other accessories may need to be loosened or removed to install the windshield.
2. Carefully open the carton and remove the windshield. Place the windshield on a large, flat surface that is clean and free of dirt. Inspect the windshield prior to installation. If you have any concerns, please contact customer service. If the protective film has been removed, the windshield is not eligible for a return.
Included Parts:
| Part | Quantity |
|---|---|
| Aero-Vent Windshield | 1pc |
| Strap Clamps | 2pcs |
| 1/4-20 x 1in SS Bolts | 3pcs |
| 1/4-20 Lock Nut | 3pcs |
| 1/4-20 Washer | 3pcs |
| Side Bulb Gasket | 42in |
| 1 1/2in Loom Clamp | 1pc |
If any parts are damaged or missing, please contact customer service at (606) 845-7439.
Tools Needed for Installation:
- Adjustable Wrench or 7/16in wrench
- Phillips Screwdriver
Installation Steps
1. Read all instructions before starting the installation.
2. Install the bulb gasket along the bottom, curved edge of the windshield. Press the gasket firmly into place and work along the edge in sections to ease installation.
3. Use two 1/4-20 x 1in bolts, two washers, and two lock nuts to attach the windshield to the frame in the top corners.
[Description of image for step 3: The upper corners of the windshield are shown being attached to the vehicle frame using bolts, washers, and nuts.]
4. Use the loom clamp, along with a bolt, washer, and lock nut, to secure the top center of the windshield to the frame.
[Description of image for step 4: The top center of the windshield is shown being secured to the vehicle frame with a clamp and hardware.]
5. Check all bolts and clamps to ensure they are tightened. Installation is now complete.
