SAT Shower Enclosure Mounting Instructions
This document provides installation instructions for various SAT shower enclosure models.
Product Models Covered
The following models are covered in this guide:
- SIKOWI80, SIKOWI80KS, SIKOWI80MR
- SIKOWI90, SIKOWI90KS, SIKOWI90MR
- SIKOWI100, SIKOWI100KS, SIKOWI100MR
- SIKOWI110, SIKOWI110KS, SIKOWI110MR
- SIKOWI120, SIKOWI120KS, SIKOWI120MR
- SIKOWI140, SIKOWI140KS, SIKOWIPROFIL, SIKOWIPROFILC, SIKOZAV2, SIKOZAV2C
- SIKOWIROZKS, SIKOWIROZ, SIKOWIROZC, SIKOWIROZCKS
General Installation Steps
The installation process involves several key stages, illustrated with diagrams and part references.
Step 1: Preparation and Wall Mounting
This step involves preparing the wall and mounting the initial components. Ensure the wall is suitable for fixing the enclosure. The diagrams show the use of screws and wall plugs for secure attachment. Water pH should be between 6.8 and 7.2 for optimal conditions.
Tools and Materials:
- Drill with a 6mm drill bit
- Screwdriver
- Hammer
- Level
- Measuring tape
- Pencil
- Silicone sealant
- Safety gloves
- Safety glasses
Diagrams illustrate:
- Drilling holes in the wall.
- Inserting wall plugs.
- Attaching brackets to the wall.
- Ensuring correct alignment and level.
Step 2: Assembling the Enclosure Frame
This stage focuses on assembling the main frame of the shower enclosure. This typically involves attaching profiles and ensuring all connections are secure.
Diagrams illustrate:
- Attaching the vertical profiles to the wall-mounted brackets.
- Sliding components into place.
- Securing the frame with screws (e.g., ST4x40).
- Checking for a snug fit and proper alignment.
Note on Easy Clean: The inner side of the enclosure is designed for easy cleaning.
Step 3: Installing the Glass Panel
This step involves carefully installing the glass panel into the assembled frame.
Diagrams illustrate:
- Lifting and positioning the glass panel.
- Securing the glass panel within the frame using provided fixings.
- Ensuring the glass is correctly seated and stable.
- Measurements such as 'L' and 'L-39mm' are indicated for precise fitting.
Step 4: Final Adjustments and Sealing
The final step involves making any necessary adjustments for a perfect fit and sealing the enclosure.
Diagrams illustrate:
- Adjusting the position of the glass panel.
- Applying silicone sealant around the base and edges for waterproofing.
- A 24-hour waiting period is recommended before use to allow the sealant to cure.
- Measurements like 100mm are indicated for specific placement of sealant or components.
Important Considerations
- Water pH: Maintain water pH between 6.8-7.2. Avoid water with pH less than 6.8 or greater than 7.2.
- Cleaning: Use appropriate cleaning agents. Avoid harsh chemicals.
- Measurements: Refer to the specific measurements provided for each model (e.g., A(mm) values for different widths).
