Safavieh PAT7090 Outdoor Coffee Table Assembly Instructions
Model: PAT7090
Brand: Safavieh
Dimensions: 22" W x 42" D x 12.6" H
Notice
- Please ensure all parts are indicated and in good condition before assembly. Refer to the part and hardware lists for guidance.
- Assemble on a soft surface to prevent scratching the finish.
- Periodic tightening may be required.
- For assistance, contact Customer Care at customersupport@safavieh.com.
Preparation
- Before assembly, verify all parts are present by comparing them with the contents list and hardware list.
- Do not attempt assembly if any part is missing or damaged.
- Estimated Assembly Time: 10 minutes.
- Tools Required for Assembly (included): Allen Key.
Care and Maintenance
Outdoor Furniture Care
- Store outdoor furniture indoors or cover it when not in use.
- Remove wooden furniture from standing water.
- Dust regularly with a small brush or vacuum.
- Clean spills immediately before they harden or stain, using a slightly dampened sponge.
Part List and Hardware List
Parts
| Piece | Description | Picture | Quantity |
|---|---|---|---|
| A | Table Top | [Illustration of a slatted tabletop] | 1X |
| B | Leg | [Illustration of a table leg] | 4X |
Hardware
| Piece | Description | Picture | Quantity |
|---|---|---|---|
| HW1 | Allen Bolt: M6x0.5x60 mm | [Illustration of an M6x60 Allen bolt] | 8X |
| HW2 | Washer Ø6.5/20x2mm | [Illustration of a Ø6.5/20x2mm washer] | 8X |
| HW3 | Allen key | [Illustration of an Allen key labeled LG4] | 1X |
Warnings
⚠ WARNING ⚠
- Weight Capacity: 40 lbs
- Warning: Do not stand on table
- Warning: Do not over torque bolts / screws
Assembly Instructions
Step 1
Place the Table Top (A) (bottom-side up) onto a clean, soft surface to avoid any scratches or damage to the product.
Loosely affix the Legs (B) into the mounting positions at the corners of the Table Top (A), then secure them using the Bolts (HW1) with Washers (HW2), and the Allen key (HW3), as shown in the diagram.
Illustration Description: Shows the tabletop (A) upside down with legs (B) being attached using bolts (HW1) and washers (HW2). An inset detail shows the bolt and washer connection. The Allen key (HW3) is also depicted.
Step 2
Turn the Table right side up.
Ensure all bolts are fully locked into position.
The Table is ready to be used.
Illustration Description: Shows the fully assembled table standing upright.
