Delta Body Spray

Limited Warranty on Delta Faucets

Parts and Finish

All parts (except electronic parts and batteries) and finishes of this Delta faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed. For commercial users, the warranty is for 5 years from the date of purchase.

Electronic Parts and Batteries (if applicable)

Electronic parts (other than batteries), if any, are warranted to the original consumer purchaser to be free from defects in material and workmanship for 5 years from the date of purchase. For commercial users, the warranty is for one year from the date of purchase. Batteries are not warranted.

Delta Faucet Company's Obligation

Delta Faucet Company will replace, FREE OF CHARGE, during the applicable warranty period, any part or finish that proves defective in material and/or workmanship under normal installation, use, and service. If repair or replacement is not practical, Delta Faucet Company may elect to refund the purchase price in exchange for the return of the product. These are your exclusive remedies.

Recommendations

Delta Faucet Company recommends using a professional plumber for all installation and repair. Genuine Delta replacement parts are also recommended.

Limitations and Exclusions

Delta Faucet Company shall not be liable for any damage to the faucet resulting from misuse, abuse, neglect, or improper or incorrectly performed installation, maintenance, or repair, including failure to follow applicable care and cleaning instructions.

Obtaining Replacement Parts

Replacement parts may be obtained by calling the applicable number below or by writing to:

• In the United States and Mexico:
  Delta Faucet Company
  Product Service
  55 E. 111th Street
  Indianapolis, IN 46280
  1-877-345-BRIZO (2749)
  customerservice@deltafaucet.com
• In Canada:
  Masco Canada Limited, Plumbing Group
  Technical Service Centre
  350 South Edgeware Road
  St. Thomas, Ontario, Canada N5P 4L1
  1-877-345-BRIZO (2749)
  customerservice@mascocanada.com

Warranty Claim Requirements

Proof of purchase (original sales receipt) from the original purchaser must be made available to Delta Faucet Company for all warranty claims, unless the purchaser has registered the product with Delta Faucet Company.

Warranty Applicability

This warranty applies only to Delta faucets manufactured after January 1, 1995, and installed in the United States of America, Canada, and Mexico.

Limitation of Liability for Damages

Delta Faucet Company shall not be liable for any special, incidental, or consequential damages (including labor charges) for breach of any express or implied warranty on the faucet. Some states/provinces do not allow the exclusion or limitation of special, incidental, or consequential damages, so these limitations and exclusions may not apply to you.

Legal Rights

This warranty gives you special legal rights. You may also have other rights which vary from state/province to state/province.

Exclusive and Transferable Warranty

This is Delta Faucet Company’s exclusive written warranty, and the warranty is not transferable.

Questions or Concerns

For questions or concerns regarding the warranty, please view Warranty FAQs at www.deltafaucet.com, email customerservice@deltafaucet.com, or call the applicable number above.

© 2013 Masco Corporation of Indiana

Installation Instructions

Step 1: Prepare the Rough Body

Remove the plasterguard (1) and test plug (2) from the rough body.

Step 2: Install the Cartridge

Install the body spray cartridge (1) into the body. Secure with the bonnet nut (2). Ensure the o-ring (3) is present on the outside of the cartridge prior to installation.

Step 3: Test for Leaks

The body spray can now be tested to look for any leakage prior to installing the trim.

Step 4: Attach Escutcheon

• For T50001: Thread the escutcheon (1) onto the bonnet nut (2).
• For T50050: Place the escutcheon (1) over the body spray and bonnet nut (2). Slide it against the wall and secure with the set screw (3).

Step 5: Install Decorative Cover

• For T50001: Snap the decorative cover (1) over the spray body cartridge (2). Align the 5 fingers (3) in the cover with the 5 slots (4) in the spray body.
• For T50050: Locate the arrow (1) on the back side of the decorative cover (2). Position the cover so the arrow aligns with either the right or left side of the spray body (3). Snap the decorative cover (2) over the spray body cartridge (3). Align the 5 fingers (4) in the cover with the 5 slots (5) in the spray body.

Parts List

T50001 Parts

• Body Spray Cartridge (RP42170)
• Bonnet (RP42169)
• Escutcheon (RP42168)
• Decorative Cover (RP42167)

T50050 Parts

• Body Spray Cartridge (RP42170)
• Bonnet (RP70257)
• Escutcheon (RP70258)
• Decorative Cover (RP70259)
• Set Screw & Wrench (RP72160)

Note: Replacement parts for chrome models have no suffix.

Troubleshooting Tips

1. Gap between cover and escutcheon: If there is too much of a gap, the rough body is in the wrong position relative to the finished wall. Disassemble the body spray, remove the rough body, and increase the distance from the finished wall to the end of the pipe nipple (refer to illustration 2). Reinstall components.
2. Cover rubs escutcheon: If the decorative cover rubs the escutcheon when rotating, the body is in the wrong position relative to the finished wall. Disassemble the body spray, remove the rough body, and decrease the distance from the finished wall to the end of the pipe nipple (refer to illustration 2). Reinstall components.
3. Low flow: If flow is disrupted for a long time, there may be a blockage on the screen provided with the rough body. Disassemble the body spray, remove the rough body. Inside the female IPS portion of the body is a removable screen. Remove and clean the screen. Ensure the screen is reinstalled. Reinstall the body spray and test.

Cleaning and Care

Clean this product with care. Although its finish is extremely durable, it can be damaged by harsh abrasives or polish. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.

Flow Rate Note: This body spray is designed to flow less than a typical body spray, approximately 1.6 GPM. If the flow is significantly lower than 1.6 GPM, and cleaning the screen did not improve the flow, contact Delta Faucet for assistance.