HOVET Mirror Assembly Instructions
Important Information
Screws for fixing the mirror to the wall are not included, as wall materials vary. For advice on suitable screw systems, contact your local specialized dealer.
Tools and Preparation
Ensure you have the following tools:
- Screwdriver ?
- Pencil ✏️
- Spirit level ?
- Tape measure ?
Diagrams show checking wall suitability and contacting IKEA for advice.
Included Parts
- 2x Brackets (Part numbers: 10146789, 10146788)
- 2x Screws (Part number: 111275)
Mounting Instructions
Mounting with Brackets
- Position the mirror against the wall where it will be mounted.
- Mark the positions for the wall brackets on the wall. The marks should be approximately 50 mm (2") down from the top edge of the mirror's intended position.
- Insert appropriate screws into the wall at the marked points. (Note: Screws are not included).
- Attach the two brackets to the mirror frame using the included screws (Part number: 111275) and nuts. Ensure the brackets are securely fastened.
- Carefully lift the mirror assembly and hang it onto the wall fixings.
Alternative Mounting Distances (for different mirror orientations)
When mounting vertically, mark points 764 mm (30 1/16") apart on the wall.
When mounting horizontally, mark points 1944 mm (76 9/16") apart on the wall.
Ensure all marks are level using a spirit level.
