Installation Instructions

Step 1:

1. Open the front door to remove the upper extension triangular trim panel.
2. Remove the foam pad from the door sheet panel.
3. Disconnect mirror connector.
4. Remove (3) 10mm hex nuts securing the factory mirror.

[Illustration of a truck door's interior, highlighting the removal of the upper extension triangular trim panel.]

Notes

Read this instruction carefully before starting installation.

Proper tools will improve the quality of installation and reduce the time required.

All mirrors are asymmetrical design for better view range.

For vehicles without factory heat and signal light functions, an additional wiring harness is required.

Power fold/Memory/Auto-Dimming functions are not available.

If missing parts or any damage are found, please take a picture and contact customer support.

Reference the vehicle owner's manual to adjust the new mirrors.

Carefully check all mirror functions before the first drive.

For vehicles with memory and tilt functions, please disable these functions in the vehicle's driver information center.

Step 2:

1. Take the new mirror and feed its studs through the holes on the door panel.
2. Connect the mirror connector.
3. Install the (3) provided hex nuts to secure the new mirror. Torque to 80 lb in.
4. Insert the foam pad into the door sheet and reinstall the upper extension triangular trim panel.

Reference Wire Diagram:

[Diagram showing an 8-pin connector layout.]

• Pin 1, 2, 5: Mirror Motor
• Pin 3: Not Used
• Pin 4, 8: Mirror Heater
• Pin 6, 7: Not Used