YITAMOTOR Quad Fold Tonneau Cover Installation Guide

Installation Steps

Step 1:

1. Clean the bulkhead and bedrail before installation.
2. Stick the seal strip onto the bulkhead.

[Image: Illustration showing cleaning the truck bed and applying a seal strip to the bulkhead.]

Step 2:

1. Place cover assembly on front truck bed rail against the cab.
2. Release safety buckles.

[Image: Illustration showing the cover assembly being placed on the truck bed rail and safety buckles being released.]

Step 3:

1. Fully unfold the cover towards rear.
2. Ensure the cover aligns on truck bed.

[Image: Illustration showing the cover being unfolded towards the rear of the truck bed.]

Step 4:

1. Carefully refold the cover without moving position on the truck bed.

[Image: Illustration showing the cover being carefully refolded.]

Step 5:

1. Slide front clamp to proper slot.
2. Pull down the front clamp to vertical position.
3. Stick the clamp pad to mounting position on bed rail.
4. Hook the J-shaped clamp under the metal bed rail lip and tighten the knob.

Note: Cutting the bedliner is necessary. The clamps may not precisely vertical.

[Image: Series of illustrations showing how to attach and secure the front clamps, including a close-up of the clamp mechanism and its placement on the bed rail. Some clamps are shown with an 'X' indicating incorrect placement and a checkmark indicating correct placement.]

Step 6:

1. Loosen the safety clamp and attach to the bed rail lip on both sides.
2. Hand tighten the knob clockwise. DO NOT use wrench or overtighten.
3. Adjust the strap to proper length, and pull the other end of the strap to tighten.

[Image: Illustration showing how to attach the safety clamp to the bed rail lip and tighten the knob. A diagram shows the bed rail, lip, knob, and clamp.]

Step 7:

1. Slide clamp to proper slot.
2. Pull down the clamp to vertical position.
3. Stick the clamp pad to mounting position on bed rail.
4. Turn the clamp handle to adjust the clamp to proper length.
5. Hook the J-shaped clamp under the metal bed rail lip and push the clamp handle to vertical position.

Note: The clamps may not precisely vertical.

[Image: Series of illustrations demonstrating the process of securing the center/rear clamps, including sliding the clamp, positioning it vertically, attaching the pad, adjusting the handle, and hooking it under the bed rail lip. An arrow indicates to push the spring lever when folding and unfolding the clamp.]

Step 8:

1. Close the tailgate. Installation completed.

[Image: Illustration showing the tailgate being closed, indicating the completion of the installation.]

Fold up the Cover:

1. Open the tailgate.
2. Release and fold up the rear clamps.
3. Fold up the cover towards front.
4. Release and fold up the center clamps.
5. Secure the safety buckles.

[Image: Illustrations showing the process of folding up the cover, including opening the tailgate, releasing rear clamps, folding the cover, releasing center clamps, and securing safety buckles.]