Aurora AU-A1ZBSCD Zigbee 3.0 LED Strip Controller

Specifications

Important Information

• The strip controller operates on 12V/24V DC and cannot be used directly with 220-240V AC mains supply.
• Remove any existing dimmers from the circuit before installation.
• The strip controller is designed to fit between a non-dimmable LED driver and the LED strip (LED driver is not included).
• Recommended LED strip length: a maximum of 10 meters for LED strips below 10W per meter, and a maximum of 5 meters for LED strips above 10W per meter. This recommendation is based on an incoming cable length of 5 meters between the driver and the start of the LED strip.
• Refer to specific LED strip data for further details.

Diagram Description: Visual representation of the controller's placement between an LED driver and an LED strip, with a warning symbol ⚠️ indicating it is not for direct AC mains use.

Connecting the LED Strip Controller to the AOne Hub

1. Download the AOne App from your device's App Store.
2. Follow the instructions within the App to put the hub into pairing mode and then pair your devices.
3. Put the controller into pairing mode using one of the following methods:
   • Connect the controller to a power outlet and turn on the power.
   • Press and hold the pairing button [button icon] for 3 seconds.
   • Power cycle the controller off for a minimum of 2 seconds and then back on again, repeating this process 6 times. Each 'on' period must be between 0.5 and 1.5 seconds.

The LED strip will flash twice to indicate it has entered pairing mode. It will flash a third time to confirm successful pairing with the hub.

Once paired, the controller can be managed and controlled using the AOne App.

Diagram Description: Visuals illustrating the app download and control interface, the pairing button on the controller, and the steps for putting the controller into pairing mode.

Installation and Compliance

• There are no specific restrictions of use for this product.
• Installation must be performed in accordance with the latest edition of the Wiring Rules by a qualified electrician.
• The earth terminal is designated for termination purposes only.

EU Declaration of Conformity: Aurora Limited hereby declares that the radio equipment type AU-A1ZBSCD is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at: www.auroralighting.com/ProductDetail/AU-A1ZBSCD

Environmental Protection (WEEE) and Warranty

WEEE Compliance: Aurora's WEEE Registration Number is WEE/BG0130YX (UK Only). Waste Electrical & Electronic Equipment Regulations require that this product must not be disposed of with other household or commercial waste. Aurora does not charge customers for WEEE disposal. To prevent harm to the environment or human health, please separate this product from other waste types and recycle it responsibly at your local facilities. Contact your local authority, recycling centre, or retailer for recycling advice. If your supplier included a WEEE disposal fee upon purchase, contact them for take-back advice.

Warranty: For full warranty details and extended warranty terms and conditions, please visit www.auroralighting.com/warranty. The warranty is invalid in cases of improper use, tampering, removal of the QC date label, installation in an improper working environment, or installation not according to the current National Wiring Regulations. If the product fails during the warranty period, it will be replaced free of charge, subject to correct installation and return of the faulty product. Aurora is not responsible for any installation costs associated with replacement. This warranty is in addition to your statutory rights.

Aurora reserves the right to alter specifications without prior notice.

(Note: WEEE and Warranty information is also provided in French, German, Italian, Dutch, Spanish, Swedish, and Arabic in the original document.)