Customer Support
Customer Service: 1-877-671-7011
Website: www.allegion.com/us
Important Safety Information
⚠️ Caution: Edges of aluminum parts may be sharp. Wear gloves and handle with care.
Installation Steps
- Measure Door Width: Measure the butt face of the door (hinge side) and note the width for cutting.
- Cut Brush and Retainer: Slide the brush out of the retainer. Cut the brush to size using wire cutters or pliers. Then cut the retainer to the same length. Reinsert the brush and peen both ends to keep it secure.
- Close the Door: Use a self-closing mechanism or manually shut the door before positioning the sweep.
- Position the Sweep: Hold the sweep against the butt face, resting lightly on the floor or threshold bevel to ensure a proper seal.
- Attach with Screws: Use the provided screws in the center of the slotted holes. This allows for adjustment. Do not tighten fully until all gasketing is in place.
- Test Operation: Open and close the door several times to ensure smooth closing and latching. Adjust if needed.
UL Classification
Positive Pressure Tested Gasketing Materials for Fire Doors. Intended for Application to/ with listed steel frames and/or classified steel covered composite, hollow metal type fire doors rated up to 3 hours, wood and plastic covered composite type fire doors rated up to 1-1/2 hours, and wood core type fire doors rated up to 20 minutes. Meets UL10B, UL10C and CAN4-S104-2010 Category J .17L5 9903
Allegion US | Redefining Access Control & Commercial Security
