D335-15 Woodanville Dining Table Assembly Instructions
Important Safety Notice
⚠️ READ CAREFULLY BEFORE BEGINNING ASSEMBLY!
- Always use proper tools.
- Follow assembly steps in order. Do not skip any steps.
- Check packing materials carefully for small parts that may have come loose during shipment. If parts are missing, contact the retailer from which you purchased the product to obtain any missing parts. DO NOT USE SUBSTITUTE PARTS.
- Periodically check to ensure that all connectors (bolts, screws, etc.) are tight.
- Keep the instructions for future reference.
- Some assembly may involve attaching glass or mirrors. Be very careful handling the glass or mirrors, as severe injury may result if the glass or mirror breaks. Never handle large pieces of glass or mirrors by yourself.
- When assembling products that have electrical cords (lamps, light, etc.), always (1) make sure the electrical cord is unplugged before assembly and (2) be careful not to twist the electrical cord during assembly.
- When assembling shelves or entertainment centers, do not stand on lower shelves in order to assemble upper shelves—use a step ladder.
- Do not stand on tables, including but not limited to, end tables, coffee tables, and dinner tables, as tables are not to support the weight of a person.
- Where assembly instructions state that the assembly requires two or more people, do not attempt by yourself as there is a risk of injury.
Ashley Furniture Industries, Inc. disclaims any liability for damages or injuries which may occur due to failure to properly follow assembly instructions, properly assemble the product, or properly use the product.
NOTE: Your unit may look different in appearance from the one shown in the illustrations on this instruction sheet.
Parts List
| Part | Description | Quantity |
|---|---|---|
| A | Table Top | 1 |
| B | Legs | 4 |
| C | Bolts (5/16" x 60mm) | 8 |
| D | Bolts (5/16") | 8 |
| E | Washers (5/16") | 8 |
| H | Allen Wrench (4mm) | 1 |
Assembly Instructions
Important Notes:
- This unit should be assembled by two or more people.
- DO NOT TIGHTEN ANY BOLTS UNTIL ALL BOLTS HAVE BEEN STARTED!
Refer to the diagram for visual guidance on attaching the legs to the underside of the table top.
1. Align the legs (B) with the pre-drilled holes on the underside of the table top (A).
2. Insert bolts (C and D) through the designated holes, along with washers (E).
3. Use the provided Allen wrench (H) to start threading all bolts, but do not fully tighten them at this stage.
4. Once all bolts for all legs are in place and started, proceed to tighten them securely.
5. Carefully turn the assembled table upright.
