ZIP IPCAI535 5MP AI Vandal Dome IP Camera

Product Overview

The IPCAI535 Vandal Dome is a robust metal exterior camera suitable for both outdoor and indoor use. It features on-board face detection and iSENSE compatibility for Face Recognition when used with the latest Zip NVR firmware. Key features include up to 40m IR range (true day/night filter), 5MP resolution, built-in PoE, and H.265/H.264 codec support.

Key Specifications:

• Image Sensor: 1/2.7" Progressive CMOS
• Resolution: 5MP (2592H x 1944V)
• Lens Type: 2.8-12mm Motorised
• IR Range: Up to 40m
• Video Compression: H.264/H.265
• Smart Features: Perimeter Intrusion, Line Crossing, Pedestrian/Vehicle Detection, Facial Detection/Recognition
• Connectivity: RJ45 10M/100M Ethernet, PoE, Micro SD Card Slot (up to 128GB)
• Operating Temperature: -30 to 60 deg°C
• Ingress Protection: IP66
• Use: For External Use

Powering the Camera

The camera can be powered in two ways:

1. Option 1: 12V DC Power

   Connect to a 12V DC power source via the 2.1mm DC socket. The current consumption is 400mA. Note that the camera is polarity sensitive, so connections must be made correctly.

2. Option 2: PoE (Power over Ethernet)

   Connect the camera using a PoE 48V RJ45 socket. When using a ZIP PoE NVR, plug the camera directly into the NVR's built-in PoE switch. The camera should become visible automatically after approximately 1 minute.

   If using a separate PoE switch or an IPmitter (wireless bridge), manual configuration may be required. Refer to the guide at www.zipdvr.com/howto/TIP459 -How-To-Add-IP-Cameras.html for assistance.

Connection Diagram Description:

The camera features the following ports: RJ45 Socket (with a weather-proof cap supplied), 2.1mm 12V DC Socket (for power input, polarity sensitive), Audio In Phono Socket, Audio Out Phono Socket, and Alarm In/Out terminals. For PoE connection, a CAT5e/CAT6 cable up to 100m Max can be used to connect to a PoE NVR or PoE switch.

Installation

Follow these steps for camera installation:

1. Step 1: Loosen the three Torx screws located on the upper housing and carefully lift off the housing. (A Torx key is supplied with the camera).
2. Step 2: Position the camera base and screw it into the mounting surface using the provided screws and wall plugs.
3. Step 3: Once the camera is correctly positioned, replace the upper housing and securely fasten the three Torx screws.

Network Configuration and Login

To search for ZIP IP cameras on your network via a Windows PC, use the ZipFinder tool. Download it from www.softcctv.com/store/Item/Zip-Finder-IP-CCTV-Security-Camera-Discovery-Tool.

Default Login Details:

Technical Specifications

Important Information

All specifications are approximate. System Q Ltd reserves the right to change product specifications or features without notice. System Q Ltd cannot be held responsible for any losses arising from errors or omissions in these instructions, or the performance or non-performance of the equipment.

[WEEE symbol: electrical waste] This symbol indicates that equipment must not be mixed with general household waste. For treatment, recovery, and recycling, please return to your local designated WEE/CG0783SS collection point as defined by your local council.