GULLABERG Chest of Drawers

Safety Warnings

⚠️ WARNING: Serious or fatal crushing injuries can occur from furniture tip-over.

ALWAYS secure this furniture to the wall using tip-over restraints.

To further reduce the risk of serious injury and death from tip-overs:

• Place heaviest items in the lower drawer.
• Do not set TVs or other heavy objects on top of this product.
• Never let children climb or hang on drawers, doors, or shelves.

Tools and Hardware Required

Ensure you have the following tools and hardware before assembly:

• Screwdrivers (Phillips and flathead)
• Hammer
• Drill with drill bits (Ø 8 mm / 5/16" and Ø 3 mm / 1/8")
• Spirit level
• Wall mounting hardware (screws, plugs, brackets, anchors)

Specific part numbers for hardware are indicated throughout the assembly steps.

Parts Overview

The GULLABERG chest of drawers consists of several components, including frame pieces, drawer slides (IKEA CL, IKEA CR), drawer fronts, sides, backs, and handles. Various fasteners such as dowels, cam locks, screws, and bolts are provided.

Refer to the diagrams in the original document for a complete list of parts and their quantities.

Assembly Steps

Follow these steps carefully to assemble your GULLABERG chest of drawers.

Step 1: Base Frame Assembly

Connect the main frame pieces using dowels (e.g., 118331) and cam locks (e.g., 119250). Secure with cam lock screws (e.g., 144574).

Step 2: Attach Side Panels

Connect the side panels to the base frame using screws (e.g., 146114) and dowels.

Step 3: Install Drawer Slides

Attach the drawer slides (IKEA CL and IKEA CR) to the inside of the side panels using screws (e.g., 101345).

Step 4: Assemble Drawer Boxes

Construct the drawer boxes by connecting the drawer sides, back, and base. Use screws (e.g., 101345) and dowels.

Step 5: Attach Drawer Fronts

Attach the drawer fronts to the assembled drawer boxes using the provided hardware.

Step 6: Insert Drawers

Slide the assembled drawers into the frame on the installed drawer slides.

Step 7: Attach Top Panel

Place and secure the top panel onto the assembled frame using the appropriate fasteners.

Step 8: Secure to the Wall (Crucial Safety Step)

To prevent tip-over injuries, it is essential to secure the furniture to the wall using the provided tip-over restraint hardware.

Wall Mounting Instructions:

• For solid walls (Type A): Drill an Ø 8 mm hole, approximately 70 mm deep. Insert a wall plug (e.g., 10087223) and screw in the bracket (e.g., 109049).
• For hollow walls (Type B): Drill an Ø 8 mm hole, approximately 30 mm deep. Insert a wall plug (e.g., 10087223) and screw in the bracket (e.g., 109049).
• For solid wood (Type C): Drill an Ø 3 mm hole, approximately 30 mm deep. Use the screw (e.g., 101345) without a plug.

If you are uncertain about the correct wall mounting method or hardware, seek professional advice.

Care and Cleaning

Carefully wipe clean with a cloth damped in a mild cleaner. Wipe dry with a clean cloth.