Zumtobel PANOS SC R150/200

Product Overview

The PANOS SC R150/200 is a lighting luminaire designed for efficient illumination. This document provides detailed instructions for installation, operation, and maintenance.

Models Covered: PANOS SC R150, PANOS SC R200

General Safety Instructions

Important Notice: Please read these instructions carefully before installation and use.

• Installation and commissioning, as well as any modifications, must only be performed by authorized personnel (qualified electricians).
• The manufacturer is not liable for damages resulting from improper installation, operation, or unauthorized modifications.
• The luminaire is intended exclusively for lighting purposes and must be installed in accordance with national regulations.
• Caution: Risk of electric shock! Disconnect mains cables and DALI control lines from the mains and verify that the power is off before performing any maintenance or assembly work.
• Neutral conductor breaks during operation can cause overvoltage damage to the lighting system. Ensure neutral disconnect terminals in three-phase AC circuits are opened only when de-energized and closed before power supply is switched back on.
• The light source in this luminaire may only be replaced by the manufacturer, their service agent, or a similarly qualified person.
• Commissioning after construction should only occur when mains voltage is continuously present.
• Dispose of packaging and the luminaire in accordance with applicable regional environmental regulations.
• Keep these instructions safe for future reference.
• Technical specifications are subject to change without notice. Contact the manufacturer for any questions.

Technical Specifications & Dimensions

Dimensions:

IP Rating:

• IP20 (standard)
• IP43: This protection rating is achieved only when the luminaire is installed in an enclosed ceiling. IP43 protection applies only from the room side.

Installation Instructions

Detailed multilingual installation steps are provided, covering various aspects of mounting and electrical connections.

Key Steps Illustrated:

• Step 1: Shows the initial mounting of the luminaire, possibly involving a ceiling adapter.
• Step 2: Illustrates electrical connections, including terminals for SWI (Switch) and LDO (Emergency Lighting). Wire cross-sections of 0.75-1.5 mm² are indicated.
• Step 3: Depicts the process of looping-in or connecting multiple luminaires in series (feed-through connection). Different connection methods are shown for 150 H/L and 200 models. Maximum current for looping-in is 8A.
• Step 4: Shows the securement of the luminaire after electrical connections are made.
• Step 5 & 6: Illustrate final assembly steps, possibly involving securing covers or reflectors.

Accessory Information

Ceiling Adapters:

• 60800898: PANOS SC R150 CEILING ADAPTER BK (Black)
• 60800899: PANOS SC R200 CEILING ADAPTER BK (Black)
• 60800894: PANOS SC R150 CEILING ADAPTER WH (White)
• 60800895: PANOS SC R200 CEILING ADAPTER WH (White)

Maintenance and Cleaning

• Dismantling: Instructions are provided for the safe dismantling of the luminaire.
• Reflector Cleaning: Use a clean reflector cleaning cloth (Part No. 60 800 118) for cleaning the reflector.

Emergency Lighting Option

The luminaire is compatible with emergency lighting systems according to EN 60598-2-22.

Mode of Operation: 0/1

Facilities: A...F

Servicing and Replaceability

Servicing of the control gear and replacement of the light source (LED) must only be undertaken by the manufacturer, their service agent, or a similarly qualified person.