Tefal X-PLORER SERIE 120 AI Quick Start Guide
This guide provides essential steps to set up your Tefal X-PLORER SERIE 120 AI robot vacuum cleaner for optimal performance.
Setup Instructions
-
Step 1: Attach Mop Pad
Attach the mop pad to the water tank.
-
Step 2: Fill Water Tank
Open the water tank of the mop support and fill it with 110ml of water. Close the water tank securely.
-
Step 3: Secure Mop Support
Clip the mop support into the two designated holes on the robot.
-
Step 4: Prepare Robot for Setup
Turn the robot vacuum cleaner upside down.
-
Step 5: Install Battery
Connect the battery cable and insert the battery firmly into its compartment.
-
Step 6: Attach Side Brushes
Clip the two side brushes onto the special spindles until they click into place.
-
Step 7: Position Docking Station
Select a suitable location for your docking station. Ensure there is at least 0.5 meters of clear space on both sides and 1 meter of clear space in front of the station. Plug the docking station into a power outlet.
-
Step 8: Initial Charging
Turn the robot upside down and switch the power on. The LED indicators will blink for approximately 50 seconds. Place the robot onto its docking station and wait until the battery indicator lights stop blinking. Allow the robot to charge fully for approximately 3 hours.
-
Step 9: Connect to App
Download the free Tefal mobile application from your device's app store [Download on the App Store] [Get it on Google Play]. Scan the provided QR code for direct access [QR code for app download]. To maximize your experience with the Tefal robot, follow the in-app instructions.
-
Step 10: Moisten Mop
Before starting a cleaning cycle that uses the mopping function, moisten the mop pad with water.
