JABLOTRON JA-110P PET - Bus-Powered PIR Detector with Basic Pet Protection

Product Overview

The JA-110P PET is a bus-powered device for the JABLOTRON system. It is used for detecting human motion in indoor environments. Unlike standard PIR motion detectors in the JABLOTRON series, this detector features a modified detection characteristic and basic pet immunity. It filters out the movement of small animals (up to approximately 25 kg in weight and up to 40 cm in height). The detector has a pulse reaction and single-zone detection. It must be installed by a trained technician holding a valid certificate issued by an authorized dealer.

Installation

⚠️ When connecting the detector to the bus, always disconnect the system power.

1. Open the detector cover by pressing the cover clip (5). Avoid touching the internal PIR sensor (11) as it may be damaged.
2. Remove the PCB – it is held in place by a clip (3).
3. Drill holes in the plastic base for screws and the cable. The recommended installation height for the detector is 2 meters from the floor.
4. Place the bus cable and fix the plastic base to the wall using screws (vertically, with the cover clip facing downwards).
5. Reinsert the PCB and connect the cables to the terminals (8).
6. Proceed according to the control panel installation manual.

Figure 1: Detector opened and description of internal and external parts.

• 1 - Holes for flat wall mounting
• 2 - Holes for corner mounting
• 3 - PCB retaining clip
• 4 - Holes for corner mounting
• 5 - Cover retaining clip
• 6 - Red LED - activation
• 7 - Yellow LED - fault
• 8 - Bus connectors
• 9 - Production code
• 10 - Cover tamper sensor
• 11 - PIR sensor

System and Setting Configuration

Use the recommended software or application depending on the control panel type; refer to the control panel manual.

Technical Specifications

Declarations and Compliance

JABLOTRON a.s. hereby declares that the JA-110P PET complies with the relevant harmonisation legislation of the European Union: Directives No. 2014/30/EU and 2011/65/EU, provided it is used as intended. The original Declaration of Conformity can be found at www.jablotron.com/downloads, in the Downloads section.

[CE Mark] [UKCA Mark]

Disposal and Environmental Information

Proper disposal of this product helps conserve valuable resources and prevent potential negative effects on human health and the environment, which could arise from improper waste management. Please return the product to your distributor or contact your local authority for more information on the designated collection point.

[Recycling Symbol]

Additional Information

For an electronic version of this document (available in other languages) or an installation version for the JA-100 system, scan the QR code provided.

[QR code present, scan for more information or alternative language versions.]