General Assembly Tips
Before you begin, ensure you have the necessary tools. You will likely need a screwdriver [screwdriver] and the included Allen key [Allen key].
Assemble the chair on a soft surface like a rug ? to prevent scratches.
Avoid assembling on hard surfaces with sharp objects that could damage the parts ❌.
If you encounter difficulties or are unsure about a step, please refer to IKEA for assistance [IKEA store] ?.
Parts List
- Bolt (Part #100159) (4x)
- Connector/Dowel (Part #100505) (4x)
- Bracket/Clip (Part #115983) (4x)
- Screw (Part #108445) (1x)
- Allen Key (Part #111631) (1x)
- Leg Support (Part #148819) (1x)
- Holder/Clip (Part #10032286) (4x)
Assembly Steps
Step 1
Attach the main leg frames to the seat base. Insert two bolts (100159) through the pre-drilled holes in the seat base and into the corresponding connectors (100505) on the leg frames. Tighten securely.
Visual Description: Shows a hand inserting a bolt into a hole, with a close-up showing the bolt passing through a connector.
Step 2
Attach the vertical side supports to the leg frames. Align the holes and insert fasteners as indicated.
Visual Description: Shows two vertical pieces being attached to the partially assembled chair frame.
Step 3
Secure the brackets (115983) to the chair frame. Use the Allen key (111631) to tighten the screws into the designated points. Ensure correct orientation as shown.
Visual Description: Close-up showing a bracket being attached and tightened with an Allen key. Another view shows a "no" symbol indicating incorrect placement.
Step 4
Repeat Step 1 to attach the second set of leg frames to the seat base, using two bolts (100159) and connectors (100505) per side.
Visual Description: Similar to Step 1, showing the other side of the chair being assembled.
Step 5
Carefully turn the chair frame upside down to access the underside for the next steps.
Visual Description: Shows the chair frame being flipped over.
Step 6
Attach the back supports to the chair frame. Use the brackets (115983) and the Allen key (111631) to secure them. Pay attention to the alignment and orientation.
Visual Description: Shows the back supports being attached to the frame, with close-ups of bracket installation using the Allen key.
Step 7
Attach the seat supports to the chair frame. Use the Allen key (111631) to tighten the fasteners.
Visual Description: Shows the seat area supports being attached and tightened with the Allen key.
Step 8
Attach the holders/clips (10032286) to the underside of the seat base. Insert them into the designated holes and ensure they are firmly in place.
Visual Description: Shows four holders being pushed into holes on the underside of the seat.
Step 9
Place the seat onto the assembled chair frame. Ensure it aligns correctly with the frame and any attachment points.
Visual Description: Shows the seat being placed onto the chair frame.
Step 10
Attach the leg support (148819) to the underside of the chair. Use the screw (108445) and a screwdriver [screwdriver] to secure it.
Visual Description: Shows a leg support being attached to the bottom of the chair with a screw.
Step 11
Attach the remaining holders/clips (10032286) to the chair legs. Push them until they click into place [click] ?.
Visual Description: Shows four holders being attached to the chair legs, with a close-up indicating a "click" sound for secure attachment.
