Product Overview and Safety Information
This manual provides instructions for the WORKPRO 24" Wide Rolling Tool Storage Cabinet. It is essential to read and understand this manual before operating or assembling the product to reduce the risk of injury.
WARNING:
- The tool cabinet is intended for indoor use only.
- Assembly requires two persons.
- Incorrect assembly may lead to damage to the cabinet or personal injury.
- All connections must be checked, and screws tightened periodically.
Safety Precautions:
- Do not open more than one loaded drawer at a time.
- Do not place tools on the door when it is open, as this may cause damage or personal injury.
Product Illustration and Dimensions
Illustration of a WORKPRO 24-inch wide rolling tool storage cabinet. The cabinet is depicted with multiple drawers, a top chest section, and wheels. Dimensions are indicated: 23.6 inches (width), 13.6 inches (depth), and 29.7 inches (height). The illustration shows the overall structure and proportions of the unit.
Parts Included
- Locking bar x1
- Top chest handle x2
- M4x8 Screw x8
- Swivel casters with brake x2
- Swivel casters without brake x2
Tools Required
- Screwdriver
- Pliers (for caster adjustment)
Assembly Instructions
Step 1: Remove the 4 Screws on Bottom
Remove the four screws located at the bottom of the cabinet base using a screwdriver.
Diagram: Showing screws being removed from the bottom of the cabinet base.
Step 2: Remove Side Panel
Remove the screws securing the side panel using a screwdriver.
Diagram: Illustrating screws being removed from a side panel of the cabinet.
Step 3: Remove Chest
Place the cabinet on a level surface. Slowly lift and remove the top chest section from the main cabinet base.
Diagram: Depicting the top chest section being lifted off the main cabinet base, placed on a level surface.
Step 4: Handle Assembly
Attach the top chest handles to the designated locations.
Diagram: Showing the attachment of handles to the drawers or chest.
Step 5: Caster Assembly
Attach the swivel casters to the bottom of the cabinet. If a caster assembly fits loosely, use a screwdriver to slightly spread apart the split bearing on the shaft. If a caster fits tightly, use pliers to slightly crimp the split bearing. Make only slight adjustments until the caster fits properly.
Diagram: Illustrating the attachment of casters to the base of the cabinet. Close-up views show how to adjust the caster fit for loose or tight connections.
Step 6: Unlock or Lock Drawers
Instructions for operating the drawer locking mechanism.
Diagram: Showing the mechanism for unlocking or locking the drawers of the tool chest.
Distribution and Contact Information
Distributed by: GREATSTAR INDUSTRIAL USA, LLC
Address: 9836 Northcross Center Court, Suite A, Huntersville NC 28078, USA
Website: www.greatstartools.com
For missing components or assembly assistance, contact Brands customer services at service@greatstartools.com.
