Removing the Vehicle Body
-
Step 1: Locate the quick release tabs as shown in the diagram above.
Image shows the underside of the RC car chassis. A person's hands are holding it, with circles highlighting two quick-release tabs located at the front and rear underside of the chassis.
-
Step 2: Twist the quick release tabs to detach the vehicle body from the chassis. An audible click will confirm the body is securely opened.
Image shows the RC car from the side. A person's hands are twisting a knob near the rear wheel arch. A close-up inset shows the detail of the quick-release knob mechanism.
-
Step 3: Remove the vehicle body.
Image shows the RC car from the side. A person's hands are lifting the yellow vehicle body away from the black chassis.
Installing the Vehicle Body
-
Step 1: Carefully position the vehicle body onto the chassis.
Image shows the RC car chassis. A person's hands are positioning the yellow vehicle body above the chassis. Downward arrows ⬇️ indicate the direction of placement.
-
Step 2: Align the vehicle body with the chassis' running boards.
Image shows the RC car. A person's hand is aligning the side of the vehicle body with the running boards of the chassis. A close-up inset shows the alignment point.
-
Step 3: Simultaneously press down on the front and rear of the body. An audible click will confirm the body is securely attached.
Image shows the RC car from the side. A person's hands are pressing down on the front and rear sections of the vehicle body. Downward arrows ⬇️ indicate the pressure points.
Land Rover and the Land Rover Logo are trademarks owned and licensed by Jaguar Land Rover Limited.
Manufactured by FMS.
