Land Rover Defender 110 SVX Electric Ride-On Car

Product Overview

This document provides installation and operation instructions for the simulated Land Rover Defender 110 SVX electric ride-on vehicle. It features forward, backward, and steering functions controllable via remote control or manual operation. The vehicle includes built-in music, external device music playback, a steering wheel music function, volume control, and a power display. The maximum weight capacity is 30 kg.

⚠️ Warning: This toy must be assembled by an adult. Adult supervision is required during use to minimize the risk of injury. Never use on roads, near motor vehicles, on or near steep slopes, stairs, swimming pools, or other water bodies. Always wear shoes, and never allow more than one person to ride at a time.

Product Specifications

Battery:

12V 9AH

Drive Motor:

12V550*2 (10000RPM) (2*35W)

Steering Motor:

12V380*1 (5600RPM)

Recommended Age:

3-8 years

Maximum Weight:

30 kg

Vehicle Size:

115*61*61 cm

Speed:

3-5 km/h

Run Time:

1 hour after 8-10 hours of charging

Charger Input:

100V-240V 50/60Hz

Charger Output:

12V 1A

Remote Control Battery:

AAA 1.5V*2 (not included)

Parts List

• A x 1: Body
• B x 2: Front Wheels
• C x 2: Rear Wheels
• D x 4: Wheel Hubcaps
• E x 1: Steering Wheel
• F x 1: Windshield
• G x 1: Backrest
• H x 1: Seat
• I x 2: Side Mirrors
• J x 1: Rear Bracket Crossbar
• K x 2: Rear Brackets
• L x 1: Snorkel
• M x 1: Winch Frame
• N x 4: Wheel Arch
• O x 2: Charger
• P x 1: Charger Plug
• Q x 1: Remote Control
• R x 10: Screws
• (Included) x 1: Wrench

Features and Controls

The vehicle features various functions accessible via buttons on the dashboard and steering wheel:

• 1. Music / Previous: Short press to switch music tracks (built-in or external). Long press to decrease volume.
• 2. Music / Next: Short press to switch music tracks (built-in or external). Long press to increase volume.
• 3. USB Interface: Connect a USB device to play music.
• 4. Power Display: Four lights indicate full charge. The green light on the right indicates charging is needed. Two lights on the right indicate critically low battery.
• 5. MP3 Interface: Insert an MP3 player to play music.
• 6. Music: Play the vehicle's built-in music.
• 7. Mode Button: Switches between built-in music and external device audio sources.
• 8. Horn Button: [Horn symbol] Press to activate the horn.
• 9. Music Button: Press to play music.
• 10. Foot Pedal: Provides power to the vehicle. Press button 14 (Forward) or 15 (Reverse) and press the pedal to move. Release the pedal to brake or slow down.
• 11. Light Button: [Light symbol] Toggles headlights and turn signals.
• 12. Speed Button: Switches between high and low speed settings.
• 13. Power Button: Toggles the vehicle's power ON/OFF. Short press to pause music playback, press again to resume, long press to turn off power.
• 14. Forward Button: Sets the vehicle to forward motion.
• 15. Reverse Button: Sets the vehicle to reverse motion.

Control Modes

The vehicle can be controlled in two modes:

• Mode 1: Remote Control: For adult use only. Allows adults to control forward, backward, and steering. The foot pedal is disabled in this mode.
• Mode 2: Manual Control: For children's independent operation. Children can select forward or reverse gear, press the foot pedal to move, and steer manually using the steering wheel.

To Switch Modes: Locate the mode switch under the seat. It is covered by a transparent lid secured with a screw. An adult must open the lid with a screwdriver. Turn the switch to 'r c' for remote control mode or 'manual' for manual control mode.

Remote Control Function and Instructions

Never switch between forward and reverse while the car is moving, as this can damage the gearbox and motor. Only the child's guardian should use the remote control. The remote control is pre-paired from the factory.

Pairing the Remote Control:

1. Turn on the vehicle's power switch.
2. Press and hold the Forward & Backward buttons on the remote for 3 seconds to start code matching; the first LED will blink.
3. Turn on the vehicle's power. The first LED will light up, indicating successful code matching.

If the remote control is not used for 10 seconds, it enters standby mode. Press any key to wake it up. Press the 'P' button to brake; all LEDs will blink, and other functions will be disabled. Press 'P' again to release the brake and restore other functions.

Battery Operating Specifications:

• Never mix new and old batteries, or different types of batteries.
• Ensure correct battery polarity; short circuits will occur otherwise.
• Non-rechargeable batteries are not to be recharged.
• Only adults should recharge or change batteries.
• Never short-circuit the power port.
• Recharge the battery only when it is taken out of the toy car.
• Keep exhausted batteries out of children's reach.
• For the 2.4G remote control model, install two AAA 1.5V batteries with correct polarity.

Assembly Instructions

Assembly must be performed by an adult. Screws and pins can be sharp before assembly.

1. Mount Front Wheels

First, remove the axle sleeve, nut, and washer from the front axle. Mount the wheel, washer, and nut onto the axle. Tighten the nut with the wrench. Finally, attach the wheel hubcap. Repeat for the other side.

2. Mount Rear Wheels

Cut the cable ties securing the gearbox. Remove the axle sleeve, nut, washer, and paper tube from the rear axle. Mount the gearbox, wheel, washer, and nut onto the rear axle in order. Repeat for the other side. Tighten the nuts with two wrenches and attach the wheel hubcaps.

3. Mount Wheel Arches

Align the wheel arches with the corresponding positions on the car body and attach them. Secure with screws. Differentiate between the left front wheel (L1), left rear wheel (L2), right front wheel (R1), and right rear wheel (R2).

4. Mount Steering Wheel

Connect the steering wheel cable to the instrument panel, then insert the cable into the cable hole. Finally, attach the steering wheel to the connector.

5. Mount Windshield, Snorkel, and Side Mirrors

Align the windshield with the car body position and secure the clip to the hole. Mount the snorkel, ensuring it hooks onto the windshield bracket and then attaches to the car body clip, pointing downwards. Insert the mirrors into the door holes. Peel off the protective film from the mirror surfaces.

6. Mount Winch Frame

Align the winch frame with the hole on the front underside of the car and secure it.

7. Connect Power Cable

Connect the power cable to the battery. Then, turn on the power to check the circuits.

8. Mount Seat

First, adjust the backrest to the desired position and mount it. Then, position the seat below the backrest and tighten the screws with a screwdriver.

9. Mount Rear Bracket

Connect the two rear brackets and the crossbar, then tighten the interfaces with screws. Mount the rear bracket into the corresponding hole at the rear of the vehicle.

Charging Instructions

Charging Procedure:

1. Find the charging port under the seat.
2. Connect the charger cable to the charging port.
3. Plug the charger into a wall socket.

Charging Notice:

• Charge the battery fully before first use, or it may be permanently damaged.
• When charging, insert the DC plug into the charging port and the charger plug into the wall socket.
• Do not use the product while it is charging.
• The product can be used for approximately 1 hour after a full charge. Charging time is 8-10 hours, and should not exceed 18 hours.
• It is normal for the charger and battery temperature to rise (below 60 degrees Celsius). Keep the charging interface away from water to prevent short circuits.
• Use only the provided charger; using other chargers may damage the charger and battery, potentially causing short circuits.
• Charge the product when it will not be used for an extended period.

Usage Instructions & Safety Warnings

• Never use the product in dangerous areas such as roads, slopes, or drains. Do not alter the circuitry or add external electrical devices.
• Never use the remote control in rainy weather or near water. Do not pour water or other liquids into the car. Keep the product away from fire to prevent damage.
• Only one child should use the product at a time, with a maximum weight limit of 30 kg.
• Turn off the power when the product is not in use. Unplug the charger when not in use for extended periods.
• Inspect the charger and its components for damage and repair if necessary.
• The product must be assembled by an adult. Be aware that screws and pins can be sharp before assembly.
• General Warnings:
• The toy must be assembled by an adult before use. The unassembled product may contain sharp points, edges, and small parts; keep out of children's reach.
• All circuit connections must be correctly made. Incorrect connections can lead to dangerous malfunctions, short circuits, or equipment failure.
• Only adults should install parts and adjust the car. Moving parts must be kept away from children. Children should only use the product under adult supervision, and the adult must not leave the vicinity during use.
• Only adults should charge the battery. Charge the product before first use. Keep packaging materials like plastic bags away from children to prevent suffocation or death.
• Do not use in traffic.
• Do not let children stand or play in the vehicle.
• Use only the battery and charger specified by the manufacturer.
• Never use parts not supplied by the manufacturer.
• Never let children play with the charger.
• The number of connected power sources must not exceed the recommended amount.
• Toys used by children in non-private areas can be potentially dangerous.
• The remote control is not a toy and is for adult use only. It is not for children. Constant adult supervision is required. Reception range may vary significantly based on weather, battery, and other environmental factors.
• Keep the packaging as it contains important information.
• This toy contains a non-replaceable battery.
• The charger should be regularly inspected for damage to the cord, plug, casing, and other parts. If damaged, do not use the toy with that charger until repaired.
• Use caution when operating the toy, as it requires skill to avoid falls or collisions that could cause injury to the user or third parties.

Troubleshooting

Maintenance and Service

Before use, parents must check the charger's wires, plug, casing, and other parts for damage and repair them. After a period of use, parents should lubricate iron parts with lubricant to prevent rust. Keep the product away from fire and store it flat in a dark place. In wet weather, store indoors or cover with a waterproof cloth.

Keep the product away from heat sources like stoves and heaters, as plastic parts may melt. Keep away from flammable objects during charging to prevent fire. Clean the car's surface with a dry cloth or plastic parts with wax-free furniture polish. Do not use chemical solutions or water to clean the car. Children should not drive in wet or rainy conditions, as this can damage the generator, electrical system, and battery.

When the product is not in use or is stored, turn off the car's power and set all switches to 'STOP' or 'OFF'. Do not use fuses that do not meet specifications. Parents should not alter the product's structure or electrical system; have it inspected and repaired by professionals or under professional guidance.

Manufacturer Information

Land Rover and the Land Rover logo are trademarks owned and licensed by Jaguar Land Rover Limited.

Licensed Manufacturer: Pinghu Qileshi Baby Carrier Co.

Distributors:

• Nordbutiker AB, Gösvägen 28, 76141 Norrtälje, Sweden
• info@rull.se
• info@ruller.no
• info@rull.dk
• info@rull.fi