The Installation Guide for Drawer Storage Cabinets (Sizes 20-45cm)
Parts Identification
Below is a list of parts and their quantities required for different configurations of the drawer storage cabinet.
| Parts | ① Top cap | ② Big drawer | ③ Side board | ④ Back pillar | ⑤ Front pillar | ⑥ Back board | ⑦ Plastic board | ⑧ Wheel |
|---|---|---|---|---|---|---|---|---|
| Three layers | 1 | 3 | 6 | 3 | 3 | 3 | 3 | 4 |
| Four layers | 1 | 4 | 8 | 4 | 4 | 4 | 4 | 4 |
| Five layers | 1 | 5 | 10 | 5 | 5 | 5 | 5 | 4 |
| Six layers | 1 | 6 | 12 | 6 | 6 | 6 | 6 | 4 |
| Seven layers | 1 | 7 | 14 | 7 | 7 | 7 | 7 | 4 |
Individual parts illustrated:
- ① Top cap
- ② Big drawer
- ③ Side board
- ④ Back pillar
- ⑤ Front pillar
- ⑥ Back board
- ⑦ Plastic board
- ⑧ Wheel
Assembly Instructions
Follow these steps to assemble your drawer storage cabinet. Assembly requires no tools.
Step 1: Assemble the Frame Base
Illustration shows the components for the first step: front bracket, rear bracket, two side plates, and a backplane.Instruction: Insert the front bracket and the rear bracket into the two side plates respectively. Then, insert the backplane into the groove of the rear bracket. Install each layer of bracket in this manner.
Step 2: Add Support Layers
Illustration shows a partially assembled cabinet with one layer installed.Instruction: After installing each layer of support, place the second layer of support on the first layer, and continue installing each layer of support in this way.
Step 3: Attach the Roof
Illustration shows the cabinet with all support layers installed and the roof being placed on top.Instruction: After all layers of support are installed, cover the roof and place the side with grooves on the surface in front of it.
Step 4: Install Wheels
Illustration shows the assembled cabinet frame turned upside down. Four wheels are depicted being attached to each side.Instruction: Place the installed cabinet bracket upside down and attach 4 wheels to each side.
Step 5: Assemble and Insert Drawers
Illustration shows a single drawer being assembled. A drawer panel with a handle is shown.Instruction: Put the panel handle face down, buckle the panel into the drawer, and finally insert the assembled drawer into the bracket of each layer.
General Information
This guide provides installation photos and instructions for drawer storage cabinets designed for sizes 20-30-45cm. The cabinet can be assembled without any tools.
