CRUZ 934-328 LCV Support Kit

Step 1: Verify Package Contents

Check all items against the list below. Ensure all parts are present before proceeding.

• 1x Package/Box
• 4x Triangular component (labeled '500')
• 4x Component (labeled '889')
• 4x Component (labeled '012-232')
• 4x Component (labeled '813-073')
• 2x Bag:
  • 1x (810-027)
  • 1x (810-114)

Step 2: Position on Vehicle

Place the support components (n° 889) onto the vehicle's roof rails at the designated points, using parts (813-073) + (012-232).

Diagram Description: An overhead view of a vehicle showing four locations on the roof rails where the support components are to be placed.

Step 3: Assemble Mounting Bracket

Attach the bracket to the base component using the provided bolt and washer. Tighten to 6 Nm.

Diagram Description: An exploded view showing a bracket being fitted onto a cylindrical base. A bolt and washer are shown. An arrow indicates the direction of assembly [Arrow A]. A hand symbol [Hand] is shown near the bolt, indicating manual handling. Torque specification: 6 Nm ?.

Step 4: Attach to Roof Rail

Secure the assembled bracket to the vehicle's roof rail. Ensure correct alignment. Roof rail dimensions are approximately 50x30 mm and 52x35 mm (Aluminum).

Diagram Description:

• The top section shows a bracket being attached to a roof rail. An arrow indicates insertion [Arrow A]. A hand symbol [Hand] is shown near the bolt.
• The bottom section shows a roof rail profile. An arrow indicates sliding a component into a channel [Arrow C]. The bracket is then attached with bolts [Arrow A], and a hand symbol [Hand] is shown. A detail shows scissors ✂️ being used, possibly to trim a protective strip.

Step 5: Secure Supports

Attach the support components to the roof rail and tighten the bolts to 5 Nm. Ensure correct orientation as shown, avoiding incorrect fitting.

Diagram Description:

• The top section shows a bracket being attached to a roof rail. An arrow indicates insertion [Arrow A]. A hand symbol [Hand] is shown near the bolt. Torque specification: 5 Nm ?. A visual comparison shows correct fitting (✅) and incorrect fitting (❌).
• The bottom section repeats the process with a 5 Nm torque.

Step 6: Final Attachment

Complete the installation by attaching the main support structure to the previously mounted brackets. Tighten bolts to 5 Nm.

Diagram Description:

• The top section shows a view of the vehicle roof [Arrow A]. A main support component is shown being attached to the brackets on the roof rail. Arrows indicate insertion [Arrow C, Arrow D]. Bolts are tightened with a 5 Nm torque ?. A hand symbol [Hand] is shown near the bolt.
• The bottom section repeats the final attachment process with a 5 Nm torque.