⚠️ WARNING

Please carefully inspect the product before assembling. If you notice any apparent damage, call your carrier claims agent and do not continue the installation until it has been reviewed. Please watch for pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any spring loaded parts. Before installing, make sure that the supporting surface will support five times the combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also layout all components to ensure that you have all of the required parts before proceeding (see BOM list on following page). Use of this product for anything other than its specified use may result in failure or personal injury. This product is intended for indoor use only. We recommend using a qualified trades person for installation. Use an assistant or lifting equipment to lift and position products.

For support, please call: +44 (0)1865 767676 or email: sales@unicol.com

Components

The following ceiling plates are available:

• CP1: Standard Ceiling Plate
• CP2: Large Standard Ceiling Plate
• CP3: Stub Column Ceiling Plate
• CP4: Large Stub Column Ceiling Plate
• CP5: Gantry Ceiling Plate
• CP6: Tilting Ceiling Plate
• CP8: Twin Column Ceiling Plate
• CP9: Twin Column, Swivel Ceiling Plate
• CPAV1: Anti-Vibration Ceiling Plate

Diagrams show various ceiling mounting plate designs, illustrating their structure and connection points. These are designed to attach to ceilings and support columns or other mounting hardware.

?️ Tools Required

• 4mm & 5mm Allen Keys
• Pozi Head Screwdriver
• 19mm Spanner
• 17mm Spanner

?‍? Installers Required

1

Installation Steps

1️⃣ Step 1: Ceiling Mounting

For models (excluding CP5 & CPSC1): Using the 4 ceiling mounting slots, determine where you want to install your mount, mark it, and fix it into position. Please consider cabling and ceiling fixings prior to installation. Ensure the surface is capable of supporting 5x the combined solutions weight.

For model CP5: Using the 8 ceiling mounting slots, determine where you want to install your mount, mark it, and fix it into position. Please consider cabling and ceiling fixings prior to installation. Ensure the surface is capable of supporting 5x the combined solutions weight.

Diagrams illustrate the ceiling plates with multiple mounting points, showing how to position and fix them to the ceiling.

2️⃣ Step 2: Column Attachment

For models (excluding CP3 & CP4): Slide all cabling through the column and through the gap in the ceiling plate socket. Being mindful of the cables, slide the column into the socket, ensuring that the two holes either side align with those on the mount. Using the through bolt, secure the column into place and tighten the two grub screws at the rear.

For models CP3 & CP4: These plates fix directly with socket-ended products such as suspension adapters and PSU mounts. Slide all cabling through the ceiling plate and attachment. Being mindful of the cables, slide the attachment over the stub column, ensuring that the two holes either side align. Using the through bolt, secure the column into place and tighten the two grub screws at the rear.

Diagrams show the process of feeding cables through the column and attaching it to the ceiling plate, highlighting alignment points and securing hardware.

Adjustments

? CP6 Tilt Adjust

To adjust the angle of the CP6, slightly loosen the connecting bolt and move the socket to the correct angle. Once set, tighten the bolt to secure.

Diagram illustrates the tilt adjustment mechanism on the CP6.

? CP9 Swivel Adjust

The CP9 offers 360° swivel as standard. When it arrives, it will have been tightened with an impact gun, making it stiff to move (to prevent unauthorised movement). To twist as desired, we recommend fitting the columns first.

Diagram illustrates the 360° swivel capability of the CP9.