GEPRC TAKER F405 BLS 50A STACK
Flight Controller (FC) Specifications
Target: GEPRCF405
MCU: STM32F405
IMU: ICM 42688-P
Blackbox: 16MB
Baro: NO
BEC: 5V, 9V
Max External Dimensions: 36 x 36mm Board
Mounting Hole Pattern: 30.5 x 30.5mm (M3)
Input Voltage: 3-6S LiPo
UART Ports: 6
Other Features: Permanently enable Airmode, OSD, Dynamic gyro notch filtering
FPV Camera Connection:
- CAM
- GND
- 5V
Receiver Connection:
- SBUS
- 9V
- GND
- SBUS
Analog VTX Connection:
- CAM
- GND
- 5V
- LED
- GND
- 5V
- LED
DJI Diagram FPV System Connection:
- RX
- TX
- GND
- 9V
- INPUT
Diagram Description: The diagram shows the main flight controller board with connections labeled for FPV camera, ESC, receiver, and VTX. It also illustrates the wiring for analog and DJI digital FPV systems, indicating specific pins for data, power, and ground.
Electronic Speed Controller (ESC) Specifications
Continuous Current: 50A
Burst Current: 55A (5s)
Support Battery: 3-6S LiPo
Support Protocol: Oneshot125/Oneshot42/Mulishot modes, Dshot 150/300/600
Support Firmware: G_H_30
ESC Connections:
- M1
- M2
- M3
- M4
- BAT
- GND
- GND
Diagram Description: The ESC board is shown with connections for motors (M1-M4), battery (BAT), and ground (GND). It also indicates current sensing (CUR) and LED connections.
Receiver Configuration
Identifier: USB VCP, UART1, UART2
Configuration/MSP: 115200
Peripherals: Disabled
Receiver Mode: Serial-based receiver (SPEKSAT, SBUS, CRSF)
Note: When using a serial receiver, configure the corresponding UART in the Ports tab and select the correct receiver protocol (e.g., CRSF, SBUS).
DJI Digital FPV System Configuration
Identifier: USB VCP, UART1, UART2
Configuration/MSP: 115200
DJI AIR Unit Module / DJI O3 AIR Unit: 7.4-26.4v
CADDX Vista: 7.4-26.4v
Receiver: Serial (via UART)
Note: The UART for the receiver must be set to 'Serial Rx' in the Ports tab. Select the correct data format from the drop-down list.
