Resistex Miks Installation Guide

Product Features & Options

The Resistex Miks is a lighting fixture available in different configurations, including options for adjustable orientation and low luminance.

Adjustable Orientation

For fixtures with adjustable orientation:

• Diagram 1: Shows the fixture body and a separate ring accessory.
• Diagram 2: Illustrates attaching the ring accessory to the fixture body.
• Diagram 3: Shows rotating the ring accessory to lock it in place, enabling adjustable orientation.

Low Luminance Configuration

For the low luminance configuration:

• Diagram 1: Shows the fixture body with integrated clips or springs.
• Diagram 2: Illustrates attaching these clips/springs to the fixture body.
• Diagram 3: Shows the fixture body being pushed upwards into the ceiling opening.

Safety Instructions

• Never work when voltage is present on the luminaire.
• The installation must be performed by a professional installer in compliance with the standards and regulations relating to electrical installations.
• Risk of electrostatic discharges (ESD Norm). Handle with precautions.
• Please observe the notes and steps described in the mounting instructions.

Maintenance Instructions

• Do not use chemicals or abrasives products to clean the fixture.
• Keep these instructions for dismantling or future maintenance.
• Additional information about RESISTEX luminaires can be consulted on the website www.resistex-sa.com.
• RESISTEX cannot be responsible for any misuse of the product.

Installation Procedure

Step 1: Prepare Ceiling Cut-out

Cut a circular opening in the ceiling with a diameter of Ø69 mm (±1 mm). A template may be used for precise marking.

Step 2: Insert Fixture

Insert the main fixture body into the prepared ceiling opening.

Step 3: Connect Main Wiring

Connect the electrical supply wires (Line and Neutral) to the fixture's connector block. The block has clearly marked terminals for L (Line) and N (Neutral). Ensure correct polarity.

Step 4: Connect Earth Wire

Connect the earth wire from the electrical supply to the designated earth terminal on the connector block.

Step 5: Secure Fixture

The fixture is secured in place using integrated spring clips or retaining mechanisms. Push the fixture into the ceiling opening; the clips will engage and hold it firmly.

Step 6: Close Connector

Close the cover of the wiring connector block securely.

Step 7: Final Verification

Perform a final check of all electrical connections to ensure they are secure and correctly made. The diagram indicates a correct connection with a green checkmark [✔️] and an incorrect connection with a red cross [❌]. Confirm the fixture is flush with the ceiling surface.

Company Information & Certifications

Company: RESISTEX EXPLOITATION

Address: 11 Quai de la Banquière CS 80010, 06730 Saint-André-de-la-Roche - France

Phone: +33 4 93 276 276

Fax: +33 4 93 276 280

Email: contact@resistex-sa.com

Website: www.resistex-sa.com

Registration: APE 2740Z - Siret 487 593 477 00010 - SAS CAPITAL 649979 € - T.V.A. F.R. 73 487 593 477

Certifications: ROHS, CLASS II, IP65, IK07, 82, 5 YEAR WARRANTY, CE